User manual HAIER HW-09CH03

[. . . ] ", fan motor runs at low speed to blow out gentle air. ", air conditioner will start cooling at low speed, blowing out gentle air. ", air conditioner will start speedy cooling, blowing out strong air. ", air conditioner stops running. <3> When set to " <4> When set to " <5> When set to " Hint When the mode selection switch is turned to " " or " the air conditioner will only blow out air without cooling. ", If the mode selection switch is turned from cooling mode to fan mode, do not turn it back until at least 3 minutes have elapsed. 4 Operation Guide Thermostat switch This switch controls the preset indoor temperature to make the air conditioner start or stop automatically, so as to reduce power consumption and operate the system both comfortably and economically. [. . . ] It is advisable to clean air filter every two weeks for longer operation. Take out the air filter 1. Press the concave parts on both sides at the lower part of air inlet grille to open the air inlet grille. As illustrated, remove the screw at the left corner of the air filter. 3 Hold the two white humps of filter mesh with . fingers (as illustrated) and take it out. Gently flap the dirt off the air filter. Carefully wash air filter in warm water (below 40*). To obtain better cleaning effect, soap water or neutral detergent may be used. Flush air filter carefully with clean water after removing dirt. Let it dry completely. Cleaning of the air filter CAUTION Power cord: Only to use an exclusive power cord. Changing installation site: If the air conditioner needs to be changed to another location, please contact the dealer that sold you the unit. 6 Maintenance Disposal of the condensed water Generally there are two methods available on disposal of the condensed water: 1. For the convenience of operation, it is recommended that air-conditioner be installed at least at the height of 760-1300 mm above the floor and no obstacles before it for a free airflow. The shutters at both sides and the top of air-conditioner should be protruded outdoors free from being blocked by wall, window, etc. The back of air-conditioner should be kept over 500mm from the obstacles (for example, wall, etc. ) (As illustrated in Fig. To have an efficient drainage, the back part of the air-conditioner should be inclined downward by 5-10mm (As illustrated in Fig. 3). cover 51m -0m support fig. 1 >500mm fig. 2 fig. 3 The enclosed accessories of the conditioner are: Name Figure Quantity Manual Drain elbow Rubber lid 1 1 1 11 Installation Guide Installation of air-conditioner (only for reference) 1. Make the wall hole or window hole (see Fig. 1). Fix the prefabricated iron frame to stable position by expansible screws. 3. Take out the conditioner and accessories from the package . If user need to retain the condensate in the bottom plate, can block the bottom hole with rubber lid and as illustrated in Fig. 2, install drain elbow to back hole of the air-conditioner, and connect drainage tube. If the user doesn't need to retain the condensate in the bottom plate, can remove the rubber lid on the bottom and install drain elbow, connect drainage tube as illustrated in Fig. [. . . ] After installation of all the accessories, put the whole machine on the iron frame. If there's water outlet flexible pipe, lead the pipe to needed position(see Fig. 4). Fill any distance between the wall hole and the machine body with flexible sponge rubber strip to prevent the entering of outer noise and the leaking of the coolness. After installation of the conditioner, insert the power plug into the outlet and perform test-run. Fig. 4 Water outlet flexible pipe(provide by user) 350 Iron frame 450 Fig. [. . . ]