User manual HAIER HW-18CM03

[. . . ] When set to "HIGH FAN", fan motor runs at high speed to blow out strong air. When set to "LOW FAN", fan motor runs at low speed to blow out gentle air. When set to "HIGH COOL", air-con will start speedy cooling, blowing out strong air. When set to "LOW COOL", air-con will start cooling at low speed , blowing out gentle air. [. . . ] Condensate runs out from the drain hole on the back of the unit. Remove the rubber stopper from the drain hole on the bottom in order to make the condensate run out. In this method the efficiency of air conditioner will be slightly lowered. In the both methods above, an extended hose (available on the market) can be connected to the drain connecting pipe if necessary. Extended pipe (hose) Cautions Power cord: Be sure to use the exclusive power cord. Change installation place: If air-con need to be changed to another place please contact the dealer, who sold you the unit. 6 Maintenance Avoid opening door and window unless necessary. Don't be exposed to cold air for a long time. Use curtain or blind Direct sunlight may reduce cooling effect, always use window curtain. Keep heat source away from air conditioner. Keep away from me No entrance Set temp. a little bit higher before going to bed. After unit stops, don't restart it until 3 min. enjoy a 3-min nap 7 Cautions Don't hang clothes in the vicinity of air inlet. This will decrease cooling effect and cause abnormal operation. Temperature should be set properly when there are infant, child, the aged or disabled in room. Go away! Baby has gone sleep had better adjust suitable temp. Before operating mode selection switch, check if the air inlet or outlet have been blocked. For longer and trouble-free operation of the unit, pay special attention to the following: Install air-con at a place strong enough to support the unit. Leave enough space around air inlet and outlet for better circulation. Problems may occur if unit is installed in the following places: Place where oil exists in the air including engine oil or seaside with salt breeze blowing and hot spring area with sulphureous gas in the air. 8 Trouble Shooting Phenomenon Check the unit Is plug firmly inserted?Resolution Readjust power supply or replace fuse. Doesn't work Is thermostat switch wrongly adjusted? Readjust the thermostat. Is direct sunlight in the room?Is mode selection switch set to "HIGH FAN" or "LOW FAN"?Are there any obstacles blocking air inlet and outlet? Use curtain or blind. No cool air or poor cooling Shut doors and windows. Remove the obstacles. Is there too much heat source in the room? Remove the heat source. Is air filter clogged? Clean it. If problems can not be solved please pull out power plug and contact your dealer. 9 Installation instruction Selection of the installation position 1. Select position where the structure is firm. Select position where the air inlet and outlet are smooth without obstacles. Select position where the cooled air can be blown to every corner. Select position where there's no direct sunlight. If the sunlight is inevitable, sun shading device is required. [. . . ] All attachments being fixed, put the air conditioner on the iron support. If there is a drain hose, lead it to a required place (see Fig. 5). Fig. 3 Drain connecting Seal circle Drain hose pipe Fig. 4 11 Installation instruction 8. Chink the wall and window with soft sponges or rubber bits in order to refrain from outside noises coming in or cooling air going out. Air conditioner being fixed, insert the power plug in the socket, open the operation panel cover, turn the temperaure setting to "Test run", turn successively the mode selection to "Hi fan" and "Hi cool", "Lo cool" and "Lo fan", inspect the air conditioner's start and running performance. Wall Drain hose Fig. [. . . ]