User manual HAIER HW70-1211N

[. . . ] Pre-wash Standard Quick wash Standard Quick wash Wool Please read these in ons carefully before using this appliance. The ins ons contain important informa on which will help you get the best out of the appliance and ensure safe and proper installa on, use and maintenance. Keep this manual in a convenient place so you can always refer to it for the safe and proper use of the appliance. If you sell the appliance, give it away, or leave it behind when you move house, make sure you also pass on this manual so that the new owner can become familiar with the appliance and safety warnings. [. . . ] We recommend using a spirit level to level the appliance. The floor should be as stable and flat as possible. Connect the nut on the inlet hose to the connector on the water valve. Apply inlet hose to a water tap with cold, fresh water. Use the hose-set supplied with the appliance. drain Hose Use the drain hose bracket to keep the end of the drain hose retained and prevents the ou low of water. Don't extend the length of the drain hose; if an extended hose is required, please consult a serviceman. The height of the drainage outlet must be 80-100 cm. Fix the drain hose to the clip at the back of the washing machine to prevent it from dropping off. The drain hose should not be submerged in water and should be securely fixed and leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the washing machine will con nuously drain while being filled (self-siphoning). conne ng to Power Supply Before connec ng to the power supply, check: The socket is adequate for the maximum power of the washing machine (For safety, fuses in the power circuit should be rated for no less than 15A). The voltage should meet the requirement. The power outlet should be capable of accep ngthe washing machine plug. Pre-wash Standard Quick wash Standard Quick wash Wool Open the drawer, three compartments can be seen: Compartment 1: Prewash detergent Compartment 2: Detergent for programs 1 to 10. For the various washing temperatures, please refer to the 3 Program Dial By turning the knob clockwise/counterclockwise, the required program can 13 Select a temperature according to the type of laundry. Note: If there is no indicator light displayed, it means cold wash. 6 Start/Pause When the washing machine is connected to the power socket and a screen start blinking, press the Power switch, the program will be cancelled. When the laundry is not balanced during spinning, the Fiber type Preset spin speed Cleans the unit on first use Laundry and they are the most efficient programs in terms of combined energy and water differ from the declared cycle temperature. The machine is use for commercial purpose the guarantee will not be valid anymore. Do not use it for purposes other than that for which On the label of each garment and wash only machine-washable garments. power Supply Connect the washing machine to the power supply (220V to 240V~/50Hz). [. . . ] The washing machine will stop op on autom ly when a washing cycle ends. The "End" sign will appear on the display. Open the washer door and take out the laundry. >> Second press Power bu on to switch OFF the powe >> Wait about 2 minutes before door could be opened. [. . . ]