User manual HAIER HW90-1279

[. . . ] Fin Diferido C C C C C 1200 1000 500 HW80-1279 Intensivo Aclarado Extra Inicio/Pausa 8kg Capacidad 1200 rpm A+++ Clase energética Encendido/Apagado Elements Thanks for purchasing a Haier Product Please read these in ons carefully before using this appliance. The ins ons contain important informa on which will help you get the best out of the appliance and ensure safe and proper installa on, use and maintenance. Keep this manual in a convenient place so you can always refer to it for the safe and proper use of the appliance. If you sell the appliance, give it away, or leave it behind when you move house, make sure you also pass on this manual so that the new owner can become familiar with the appliance and safety warnings. [. . . ] Note: If there is no indicator light displayed, it means cold wash. 5 Spin Speed will be displayed on the indicator. Note: If there is no indicator light displayed, it means no spinning. Different water temperatures and spinning speeds can be set for special requirement. 6 8 FuncƟons 7 Extra Rinse Press this buƩon, the washing machine will perform addiƟonal rinses. Press the buƩon once to select one addiƟonal rinse. Press the buƩon repeatedly and the screen will display "P-2''or "P-3'', indicaƟng two or three addiƟonal selected rinses. The "extra rinse light" is acƟvated and flashes during the performance. "P-1/2/3" is displayed alternaƟng with the remaining Ɵme. The light turns off and the display disappears when the extra rinse ends. Select this funcƟon when programe 1-9 is selected. 8 Start/Pause BuƩon When the washing machine is connected to the power socket and a program is selected, lightly touch this buƩon to start operaƟon. During a wash cycle, touch it lightly , operaƟon will stop and the digits on the screen start blinking. To cancel a wash program during a wash cycle, touch this buƩon, when the digits on the screen start blinking, press the Power switch, the program will be cancelled. Before a washing program, select this program to set the washing load (1/2Full), the washing machine will automaƟcally adjust the water consumpƟon and washing Ɵme. informaƟon as remaining wash Ɵme and error messages will be shown here. AŌer a wash program is started the display will go on and the remaining wash Ɵme decreases. As the water pressure and temperature may differ, the remaining Ɵme may be adjusted accordingly. When the laundry is not balanced during spinning, the Ɵme may be automaƟcally prolonged. 11 Delay Touch this buƩon lightly, the washing machine will start operaƟon aŌer a period of Ɵme and the corresponding indicator will go on. 5-24 hours; each touch of this buƩon increases a half hour. AŌer the buƩon is set, press the Start/Pause buƩon to start countdown of the set Ɵme (the Ɵme is displayed on the screen unƟl the program ends). [. . . ] Clean the filter and check the drain hose for blockage. Make sure that tap is turned on, and water pressure is normal. Make sure the drain hose is not in water. AŌer the last rinsing cycle finishes, spinning fails completely due to unbalance of the laundry. [. . . ]