User manual HAIER HWR08XC3-T

[. . . ] 0010552275 English 1 English 2 English 1 1 2 4 4 5 5 6-7 8-14 8 8-14 15-19 16 16 17-19 20-21 21-22 23 3 English Important: Test power plug before each use: 1. Press ìtest ìbutton, unit should trip. [. . . ] Instant Mount models are designed for windows wide(the detail See Page 17) . Instant Mount kit supplied with unit is designed for mounting in most double-hung windows without storm windows. For installation in window frame with storm window, modify sill by adding wood strips (not included) to inner and outer sills. This raises unit and eliminates interference of storm window frame. Storm window installation If storm window frame does not allow adequate clearance below sill (1/2î required), remove storm window frame or create clearance by adding a wood strip (at least 1 1/2î wide) along entire width of sill. Fasten wood strip to sill with at least three countersunk wood screws (not supplied with kit). This provides a smooth surface for mounting air 1/2" conditioner. Minimum 1 1/2" Minimum Mobile home window installation Add wood strip (at least 1 1/2î wide) along entire width of window sill. Thickness of wood strip should match height of front lip on window frame. Fasten wood strip to sill with a minimum of three countersunk wood screws (not supplied with kit). This provides a smooth surface for mounting air conditioner. Must be a minimum of 1/2" to clear bottom rail on unit 1 1/2" Minimum Wood Strip Window Frame Wood Strip SILL I N D O O R Storm Window Frame O U T D O O R I N D O O R O U T D O O R 3 T rail op INSTALL UNIT WINDOW IN 4 INSTALL BASEPAN ANGLE Place unit in window. Lower sash until it rests behind front flange of top rail. Bottom rail must rest behind window sill. Back front attachment screw out several turns and slip Basepan Angle over screw head. Snug screw with angle resting on window ledge. Install Two 31/32" screws through angle into window ledge. [. . . ] DO NOT use your air conditioner without the air filter in place. To clean the front panels or the cabinet DO NOT use harsh chemicals, abrasives, ammonia, chlorine, bleach, concentrated detergents, solvents or metal scouring pads. Always use a soft cloth dampened with water or mild soap and water solution to wipe the front of the cabinet. 20 English 21 English (See page 8) (See page 18) 22 English [. . . ]