User manual HAIER RDG 350 AW

[. . . ] Actual model may vary per model purchased. Before beginning installation, carefully read these instructions. this will simplify the installation and ensure the dryer is installed correctly and safely. NOTE: The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/ NFPA 70 or in Canada, CSA C22. [. . . ] Installation must conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is not applicable, with American National Standard for Mobile Homes. The following are specific requirements for proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/or fire hazard. This appliance must be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow the instructions in this manual for proper grounding. Do not use an extension cord with this dryer. Some extension cords are not designed to withstand the amounts of electrical current this dryer utilizes and can melt, creating electric shock and/or fire hazard. Locate the dryer within reach of the receptacle for the length power cord to be purchased, allowing some slack in the cord. Refer to the electrical requirements in this manual for the proper power cord to be purchased. A UL approved strain relief must be installed onto power cord. Attach the white (neutral) power cord conductors to the outer cord and the green ground wire from the dryer harness to the brass-colored center terminal on the terminal block. Tighten the screws securing the cord restraint firmly against the power cord. Semi-rigid or approved pipe from gas supply line to the 3/8 inch (0. With the dryer in its final position, adjust one or more of the legs until the dryer is resting solid on all four legs. Plug the power cord into a grounded outlet. NOTE: check to ensure power is OFF at WARNING circuit breaker/fuse box before plugging the power cord into the outlet. Turn on the power at the circuit breaker/fuse box. Before operating the dryer, make sure the dryer area is clean and free from combustible materials, gasoline, and other flammable vapors. Run the dryer through a cycle check for proper operation. NOTE: On gas dryers, before the burner will light, it is necessary for the gas line to be bled of air. If the burner does not light within 45 seconds the first time The dryer is turned on, the safety switch will shut the burner off. [. . . ] 90 days labor from date of original purchase. 90 days parts from date of original purchase NO OTHER WARRANTY APPLIES. For the name and telephone number of the nearest authorized service center please call 1-877-337-3639. Before calling please have available the following information: Model number and serial number of your appliance( found on the rear of the unit on the upper left hand side). [. . . ]