User manual HAIER VDW6SS

[. . . ] - This dishwasher is designed for washing household dishes and cooking utensils. - Do not install this appliance outdoors exposed to the rain and elements, even if a roof covers the area. - Do not lean or sit on the door when it is open, as it may overturn the dishwasher. - Do not touch the heating element during or after a wash cycle. [. . . ] If the pots and pans have baked-on food that is extremely hard to remove, we recommend they are soaked before washing. This will eliminate the need for extra wash cycles. Pull out the rack to load the dishwasher. Lower Rack Upper Rack The lower rack Place the most difficult to clean items on the bottom rack: pots, pans, lids, serving dishes and bowls. It is preferable to place serving dishes and lids on the sides of the racks in order to avoid blocking the rotation of the top spray arm. - Deep pots should be tilted to allow the water to flow out. Load for 12 Standard Settings The upper rack The upper rack is designed to hold more delicate and lighter dishes, such as glasses, cups and saucers, plates and small bowls. - Position the dishes so that they do not get moved by the spray of water. To adjust the height of the upper rack, rotate the caps located on the end of the rack guide rails to the side, remove the rack completely and refit using the alternate set of whells (see fig. B). Adjust the upper basket to the higher level to allow more height in the bottom basket for large items. 3 1 2 4 fig. A fig. B . 4. Turning on the Appliance Starting a wash cycle - Make sure that the appliance is plugged in and switched on. - Make sure that the water supply is turned on. - Load the detergent (see the section entitled, "Detergent and Rinse Aid" on page 3). - Turn the timer dial located on the right of the control panel in a clockwise direction until it points to the number or symbol of the cycle required (see the section entitled, "Wash Cycle chart" on page 7). - Press the Power button, the Power light will turn on and the wash cycle will begin. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. Cancelling or changing a wash cycle setting A cycle that is underway can only be changed if it has been running for a short time. Otherwise, the detergent may have al- If you forget to load some of the dishes The wash cycle can be paused by pressing the Power button. You can then load additional dishes and turn the appliance back on. The cycle willcontinue from where it left off. ready been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent" on page 3). Press the Power button, and the on light will turn off. Rotate the dial in a clockwise direction to the desired cycle setting (see the At the end of the wash cycle When the dial stops turning and is pointing to a STOP mark (see fig), the cycle has finished. Turn the appliance off using the Power button, turn off the water supply and open the door of the dishwasher. section entitled: Starting a wash cycle ?F. [. . . ] To remove the filter assembly, pull the handle in an upward direction. The entire filter assembly (made up of the semicircular filter "A" and the fine filter "B") should be cleaned at least once a month use a soft brush. To reassemble, inset the entire assembly into the dishwasher, locate it correctly in its seat and pressing downward. The dishwasher must not be used without the filters. [. . . ]