User manual HAIER WDNS116BBS

[. . . ] When using this appliance, always exercise basic safety precautions, including the following: 1. Read all of the instructions before using this appliance. Use this appliance only for its intended purpose as described in this use and care guide. This water dispenser must be properly installed in accordance with the installation instructions before it is used. [. . . ] ⷠImproper use of the plug may result in the risk of electric shock. ⷠConsult a qualified electrician or service technician if the grounding instructions are not completely understood or if in doubt as to whether the appliance has been properly grounded. This appliance must be plugged into a 15Amp, 115 Volt, 60Hz GROUNDED OUTLET. Note: Where a standard two-prong outlet is encountered, it is the personal responsibility and obligation of the consumer to have it replaced with a properly grounded three-prong outlet. We do not recommend the use of an extension cord with this unit. POWER INTERRUPTIONS Occasionally, there may be power interruptions due to thunderstorms or other causes. Remove the power cord from wall outlet when a power outage occurs. When power has been restored, re-plug the power cord into wall outlet. This water dispenser maintains instant hot and cold water for your cooking and drinking needs. Note: The hot water faucet is equipped with a child safety lock to prevent accidental spilling of hot water. To release the hot water flow, push the child safety lock button down and as you push in the hot water button. Caution: Be careful when carrying hot water in your cup or container to avoid any injury or harm from spills. Heating Function: Heating indicator will flash on the display, until the temperature reaches the set temperature, then heating indicator will stop flashing. Heating Level: When setting the heating temperature, additional bars will be added as you increase the heating temperature from 190°F (Min) to 203°F (Max). Cooling Function: Cooling indicator will flash on the display, until the temperature reaches the set temperature, then cooling indicator will stop flashing. Cooling Level: When setting the cooling temperature, additional bars will be added as you increase the cooling (decreasing temperature) from 50°F (Min) to 43°F (Max). Anti-Overheat Indicator: When water dispenser is heating, if the hot water tank is out of water, the water dispenser will stop heating and the Anti-Overheating indicator and left 2 bars on the Heating Level and right 2 bars Cooling Level displays will flash. When the Anti-Overheating indicators flash, fill the water tank and follow Start-Up Instructions. Troubleshooting display: when the screen shows the left and right bars of the Heating Level display flashing, it shows a heating sensor problem. When the screen shows the left and right bars of the Cooling Levels display flashing, it shows a cooling sensor problem. Turn off and unplug the water dispenser then follow the Start-Up Instructions. PLEASE NOTE: You need to press the Hot/+ (#4 below) button to turn on the water heater and the Cold/- (#5 below) button to turn on the cooling compressor. [. . . ] ⷠYou must store the unit at room temperature. ⷠAvoid storing the unit where the temperature is at or below freezing. ⷠWhen moving, the unit must be moved vertically. DO NOT move the unit in horizontal position as this may cause possible damage to internal parts. [. . . ]