User manual HAIER XQG50-QF800

[. . . ] For safety, keep children away from the washing machine. 7. Do not allow children play with the packing materials after unpacking. 1 Matters Needing Attention 8. The washing machine must net be used in the open or in area of high moisture as water droptets may form on electrical components, Air dry the appliance if the washing machine components become wet. 9. The washing machine should be place in a well ventilated area maintaing a space between walls or furniture. Wiring Circuit I1 A9 2 b a D. T. [. . . ] fill the holes left by the packing bolts with plastic plugs. (Attention: the packing bolts and rubber hose should be kept in a safe place for later use) Drainage failure Drainage hose is blocked Drainage hose end is below 100cm above the floor level Strong vibration during spin Some packing fixing bolts removed Washing machine on a uneven surface Operation stops before completion of the wash cycle Water or electricity failure Fig 2 Adjusting the position of the washing machine . There are adjustable feet under the bottom of the washing machine. Before use, the washing machine should be adjusted, as shown in figure 3, so that it is level. Excessive foam in the drum The detergent is not a Iow foam type Excessive detergent has been used Fig 3 4 13 Maintenance 1. Turn of the water and electricity supply after every wash. Open the door to prevent the formation of moisture and odors. If the washing machine is left idle for a long period, drain any remaining water in the machine and replace the drainage hose. Clean the detergent compartment regularly. For the detergent compartment similar to figure (a), raise the compartment slightly to remove and replace after cleaning. Unplug the machine during cleaning and maintenance. Use a soft cloth dampened with soapy liquid to clean the machine case and rubber components. Do not use corrosive or abrasive chemicals or solvents. Installation Connection of water inlet hose and washing machine 1. Place the water inlet hose nut on the connector of the water inlet valve. water inlet hose nut 2. slightly shake the water inlet hose nut to see if it is tightly and properly fixed. connector of water inlet valve 4. Cleaning the Filter (once a month) Press the lower edge of the filter compartment cover to open; (Fig1-2) Remove the filter by turning counterclockwise; (Fig3) Flash clean with running water; Filter replacement is the reverse of removal, Caution: Attention shall be paid to ensure that the filter is replaced correctly to avoid possible leakage. Water drainage hose The height of the terminal of the water drainage hose should be between 80cm-100cm, the water drainage hose must be securely placed on the clip on the back of the washing machine. Use the water drainage support supplied as an accessory for proper installation of the water drainage hose . fix the water drainage hose support with waterproof sring. Do not use an excessively long water drainage hose and contract the authorized technician if the water drainage hose needs to be extended. the water drainage hose should not be extended more than250cm. (longer extension will result in concurrent water inflow and outflow). The diameter of the extension hose should be the same as the original hose. caution:water drainage hose must not be immersed in water. the original and extension hoses should be tightly connected . fig. 1 fig. 2 fig. 3 Fig (a) Connection of power supply 5. To prevent blockages to the water supply or the ingress of contaminants, clean the water inlet and inlet water filter regularly. If the washing machine is left idle for a long period turn off the water and electricity supply and open the door slightly to prevent the formation of moisture and odors. If the machine is to be moved a distance location, replace the vibration mounting locks which were removed during installation as shown below. Check the following items before connection to the power supply. [. . . ] dry cleaning solvent should not be used such as trichhloroethylene or alike (caution :load the required amount of detergent only). 3. Laundry treament sort out clothes according to type and extent of dirt. There are three types of clothes: cotton, synthetical and woolen (silk) fabrics. If whites and coloreds are combined for one load, make sure the coloreds are colorfast. [. . . ]