Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HAMPTON BAY HB30-L. We hope that this HAMPTON BAY HB30-L user guide will be useful to you.
Lastmanuals help download the user guide HAMPTON BAY HB30-L.
Detailed instructions for use are in the User's Guide.
[. . . ] This symbol indicates the possibility of injury or damage to property only.
s Meanings of symbols used in this manual are as shown below.
Be sure not to do. Be sure to follow the instruction.
WARNING
Installation
Always install the expansion panel(s). Do not place the power cord near a heater.
· Improper assembly or installation may cause incorrect operation, including injury, fire, and electric shock hazards.
· It may cause fire and electric shock.
Do not use the power cord near flammable gas or combustibles such as gasoline, benzene, thinner, etc.
Do not disassemble or modify products.
· It may cause explosion or fire.
· It may cause electric shock and failure.
Gasolin
Service Manual 3
Safety Precautions
Operation
Plug in the power plug properly. · Otherwise, it will cause electric shock or fire. [. . . ] (Refer to wiring diagram on page 19 in this manual or on control box. )
Figure 16
Figure 17
Service Manual 13
Disassembly
Air Handling Parts
4. Disconnect the unit from the power source. Remove tape that attached the air guide upper and lower. Re-install by referring to the procedures above.
Figure 18
5. Disconnect the unit from the power source. Remove 2 screws that secure the condenser to the base pan. Remove the screw that secures the shroud to channel of condenser. Press the snap area of shroud with your thumbs. This allows you to remove it from the condenser. Remove 1 screw that secure the evaporator to the base pan. Remove the orifice by pushing the snap area of the air guide blower. Remove all the leads of the thermostat terminals. Re-install the components by referring to the removal procedure above.
Figure 27
12. Remove all the leads of the rotary switch terminals. Remove the rocker switch. (See Figure 28) 5. Re-install the components by referring to the removal procedure above.
Figure 28
13. Disconnect the unit from source of power. Remove a screw that secures control panel to control box. Re-install by referring to procedures above.
Figure 29
Refrigerating Cycle
14. Discharge the refrigerant by using a refrigerant recovery system. Remove 2 screws which fasten the condenser. After discharging the refrigerant completely, unbraze the interconnecting tube at the condenser connections. [. . . ] If the motor hums or noise appears to be internal while running, replace motor. If not within limits, call an electrician. Check the wire connections; if loose, repair or replace the terminal. If the wires are disconnected, refer to wiring diagram for identification, and replace the wires. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HAMPTON BAY HB30-L
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HAMPTON BAY HB30-L will begin.
