User manual HANNA INSTRUMENTS C 9800

[. . . ] Handling Reagent Vials: Handle the vials very carefully and wear protective clothing. After use, dispose of the reagent vials according to local regulations. Safety Equipment: When operating with Reactor use protective clothing, including goggles or face mask, and gloves. Use of the optional safety shield is highly recommended. [. . . ] If under warranty, report the model number, date of purchase, serial number and the nature of the failure. If the repair is not covered by the warranty, you will be notified of the charges incurred. If the instrument is to be returned to Hanna Instruments, first obtain a Returned Goods Authorization Number from the Customer Service department and then send it with shipment costs prepaid. When shipping any instrument, make sure it is properly packaged for complete protection. To validate your warranty, fill out and return the enclosed warranty card within 14 days from the date of purchase. Reproduction in whole or in part is prohibited without the written consent of the copyright owner, Hanna Instruments Inc. , Woonsocket, Rhode Island, 02895 , USA. Hanna Instruments reserves the right to modify the design, construction and appearance of its products without advance notice. FUNCTIONAL DESCRIPTION FRONT PANEL 6) Power switch: Turns the instrument ON and OFF. switch When the power button is set in the ON position the power indicator will light. 7) Fuse holder: The fuse is placed near the case for easy holder maintenance operations. 8) Power supply: 115 or 230 VAC, depending on model. supply OPERATING 1) Heater block: can warm up to 25 samples. indicator: 2) Power LED indicator Lights when the power button on the back of the instrument is switched ON. indicator: 3) Heating LED indicator Lights only when the heater is working (warming up). When the indicator cycles ON and OFF, the heater is maintaining stable the set temperature. switch: 4) Temperature mode switch Selects 105 or 150 ºC (221 or 302 ºF) operation mode. Timer: 5) Timer The knob allows to control the heating procedure. It is possible to choose: mode: § Timed procedure mode when the timer is set between 0 and 120 minutes, the heater will maintain constant the selected temperature for the remaining time. The reactor will shut off at the end of the elapsed time and will inform the user with an acoustic alarm. mode: § infinity mode the heating indicator will light when the heater is operating. The heater block will remain at the selected temperature as long as the instrument power is ON. REAR PANEL Notes: · Use of the optional safety shield is strongly recommended to protect the operator from splattering reagents in case of a vial should break. · Do not place the Reactor near heating or cooling source. [. . . ] If some reagent accidentally spills into the heater block, disconnect power and allow the instrument to cool; then remove all tubes and clean the block. Should overheating occurs, the reactor automatically shuts down. Contact your dealer or your nearest Hanna Service Center for maintenance. Fuse replacement Replace fuse only with fuse of specified type and current rating. [. . . ]