User manual HANNA INSTRUMENTS HI 147-00

[. . . ] Instruction Manual Check-fridge thermometers HI147-00 HI147-01 Dear Customer, Thank you for choosing a Hanna product. This manual will provide you with the necessary information for the correct operation of the meter. Please read it carefully before using the meter. [. . . ] Note: Conserve all packing material until the instrument has been observed to function correctly. Any defective item must be returned in its original packing. These Instruments are in http://www. hannainst. com Compliance with the CE Directives Hanna Instruments reserves the right to modify the design, construction and appearance of its products without advance notice. 1. TEST/READ switch SPECIFICATIONS HI 147-00 Range -50. 0 to +150. 0°C Resolution 0. 1°C Accuracy (@25ºC/77ºF) ±0. 3°C (-20 to 90°C) ±0. 5°C (outside) Typical EMC Deviation ±0. 5°C HI 147-01 Range -58. 0 to +302°F Resolution 0. 1°F (-58. 0 to 199. 9°F), 1°F (200 to 302°F) Accuracy (@25ºC/77ºF) ±0. 5°F (-4 to 194°F) ±1°F (outside) Typical EMC Deviation ±1°F Common specifications Probe Stainless steel probe with 1m silicone cable Battery Type/Life 1 x 1. 5V AAA typical 3 years of continuous use Dimensions 93 x 39 x 31mm (3. 7 x 1. 5 x 1. 2") Weight 60g (2. 1oz) OPERATIONAL GUIDE TAKING MEASUREMENTS · Turn the meter ON and select READ on the TEST/READ switch. · The temperature value will be displayed on the LCD. · Wait for a few seconds for the reading to stabilize. CALIBRATION CHECK Select TEST on the TEST/READ switch. If the meter is calibrated, the display will stabilize and show "0. 0" (HI 147-00) or "32. 0" (HI 147-0) in a few seconds. To return to measurement mode, move the TEST/READ switch back to READ. Contact your dealer or your nearest Hanna Service Center for recalibration, if necessary. Notes: · Do NOT wrench the probe or put heavy objects on the cable. If the cable is damaged, the meter needs to be replaced. · Variations in readings or fading display can indicate a low battery level. CE DECLARATION OF CONFORMITY Recommendations for Users Before using these products, make sure that they are entirely suitable for the environment in which they are used. Operation of these instruments in residential areas could cause unacceptable interferences to radio and TV equipment. Any variation introduced by the user to the supplied equipment may degrade the instrument's EMC performance. To avoid electrical shock, do not use these instruments when voltages at the measurement surface exceed 24 VAC or 60 VDC. To avoid damages or burns, do not perform any measurement in microwave ovens. BATTERY REPLACEMENT When the display fades, remove the two screws on the back. Remove the cover and replace the 1. 5V AAA battery while paying attention to its polarity. WARRANTY HI 147-00 and HI 147-01 are warranted for one year against defects in workmanship and materials when used for its intended purpose and maintained according to instructions. [. . . ] To validate your warranty, fill out and return the enclosed warranty card within 14 days from the date of purchase. Reproduction in whole or in part is prohibited without the written consent of the copyright owner, Hanna Instruments Inc. , Woonsocket, Rhode Island, 02895 , USA. 09/2000 - R1 Replace the cover and tighten the two screws. Battery should be replaced only in a safe area using the battery type specified in this instruction sheet. [. . . ]