User manual HANNA INSTRUMENTS HI 955501

[. . . ] This instrument is in compliance with the directives EN 50081-1 and EN 50082-1. ins rum n s TABLE OF CONTENTS °C PT100 THERMOMETER ON OFF Preliminary Examination . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 General Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Functional Description & Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Note: Save all packing material until you are sure that the instrument functions correctly. All defective items must be returned in their original packing. FUNCTIONAL DESCRIPTION AND SPECIFICATIONS ins rum n s °C 1 PT100 THERMOMETER ON OFF RANGE: -199. 9°C to 199. 9°C -200°C to 850°C 2 RANGE 3 HI 955501 GENERAL DESCRIPTION HI 955501 allows temperature measurement using interchangeable PT100 probes. HI 955501 allows temperature measurements with two different resolutions: 0. 1°C between ±199. 9 and 1°C outside. Standard features include low battery detection and self-explanatory symbols to remind the user of the operating mode or condition. 1. Range Key Range Resolution -199. 9 to 199. 9°C -200 to 850°C 0. 1°C (±199. 9°C) 1°C (outside) Accuracy for one year, excluding probe error Low Range ±0. 2°C & ±1 digit (-120 to 200°C) ±1°C & ±1 digit (outside) High Range ±1°C & ±1 digit (-170 to 450°C) ±1% F. S. & ±1 digit (outside) Typical EMC Deviation Probe Battery Type Life Environment Dimensions Weight ±0. 5°C HI 768 series (not included) 9V 150 hours of continuous use 0 to 50°C (32 to 122°F) 95% RH 143x80x38 mm(5. 6x3. 2x1. 5") 320 g (11. 3 oz. ) 2 1 Untitled-9 5 6 OPERATIONAL GUIDE LOW BATTERY DETECTION When the battery is low the user is prompted by the appearance of the "V" symbol to replace the battery. INITIAL PREPARATION Slide the battery cover off the rear of your thermometer. Remove the battery and unwrap it prior to connection to the battery connector. Insert the 9V battery and replace the cover. To switch on, press the ON/ OFF key on the front of the unit. If a temperature probe is plugged in, the unit will display the temperature. If not plugged in, the display will show "-1. ". V 9 VOLT BATTERY Battery Compartment SLIDE OFF ON OFF DISPLAY CODE GUIDE Display -1. V °C Description The probe is not connected to the instrument or the reading is out of range Weak battery, needs to be replaced The instrument is reading in the Centigrade scale °C To switch your thermometer off, press the ON/OFF key again. MEASUREMENT RESOLUTION When switched on, the instrument defaults to the last selected resolution. The instrument automatically changes its resolution to 1 degree when it passes the limit of the lower range (±200°C). RANGE CALIBRATION All Hanna Instruments thermometers have been accurately pre-calibrated at the factory. It is generally recommended to have all thermometers recalibrated at least once a year. For an accurate annual recalibration, contact your nearest Hanna Service Center. 4 3 Untitled-9 7 8 BATTERY REPLACEMENT When the battery is low the user is warned by the "V" symbol on the instrument's display. Replace the battery immediately. SHOCKPROOF RUBBER BOOTS These rubber boots are specially made to prolong the life of your instruments and to prevent damages due to accidental falls. They measure 155 x 90 x 45 mm (6. 1x3. 5x1. 8") and are available in two different colors: HI 935BTY = orange colored HI 935BTB = blue colored. Select the proper color according to your preference. V Battery replacement must only take place in a non hazardous area using the battery types specified in this instruction manual (see page 7). Remove the battery compartment cover on the rear of the meter and replace the 9V battery with a new one. [. . . ] Hanna Instruments reserves the right to modify the design, construction and appearance of its products without advance notice. 8 Untitled-9 11 12 CE DECLARATION OF CONFORMITY DECLARATION OF CONFORMITY We Hanna Instruments Srl V. le delle industrie 12 35010 Ronchi di Villafranca (PD) ITALY herewith certify that the thermometer HI 955501 has been tested and found to be in compliance with the following regulations: IEC 801-2 IEC 801-3 EN 55022 Electrostatic Discharge RF Radiated Radiated, Class B Date of Issue: 13-03-1996 D. Volpato - Engineering Manager On behalf of Hanna Instruments S. r. l. MANPT100R1 05/96 Recommendations for Users Before using this product, make sure that it is entirely suitable for the environment in which it is used. Operation of this instrument in residential area could cause unacceptable interferences to radio and TV equipments, requiring the operator to take all necessary steps to correct interferences. Any variation introduced by the user to the supplied equipment may degrade the instrument's EMC performance. [. . . ]