User manual HANNA INSTRUMENTS HI 95771

[. . . ] Instruction Manual HI 95771C Chlorine Ultra High Range ISM MAN95771CR3 06/06 w w w . h a n n a i n s t . c o m www. hannainst. com This Instrument is in Compliance with the CE Directives Dear Customer, Thank you for choosing a Hanna product. This manual will provide you with the necessary information for the correct use of the instrument. Please read it carefully before using the meter. If you need additional technical information, do not hesitate to e-mail us at tech@hannainst. com. [. . . ] It is important that both the measurement and the calibration (zeroing) cuvets are optically identical to provide the same measurement conditions. Whenever possible use the same cuvet for both. It is necessary that the surface of the cuvet is clean and not scratched. This to avoid measurement interference due to unwanted reflection and absorption of light. It is recommended not to touch the cuvet walls with hands. Furthermore, in order to maintain the same conditions during the zeroing and the measuring phases, it is necessary to close the cuvet to prevent any contamination. · After a few seconds the display will show "-0. 0-". The meter is now zeroed and ready for validation. · Remove the cuvet and place the CAL CHECKTM Standard HI 95771-11 Cuvet B into the holder. Ensure that the notch on the cap is positioned securely into the groove. · Press CAL CHECK and "SIP" will blink during measurement. · Wait for a few seconds and the display will show the validation standard value. The reading should be within specifications as reported on the CAL CHECKTM Standard Certificate. If the value is found out of specifications, please check that the cuvets are free of fingerprints, oil or dirt and repeat validation. If results are still found out of specifications then recalibrate the instrument. 18 7 FUNCTIONAL DESCRIPTION 1) 2) 3) 4) 5) 6) 7) Liquid Crystal Display Cuvet Holder Cuvet alignment indicator ON/OFF key ZERO/SET key READ/TIMER key CAL CHECK key · Hold READ/TIMER for three seconds. The display will show the countdown prior to measurement. Alternatively, wait for 1 minute and just press READ/TIMER. In both cases "SIP" will blink during measurement. · The instrument directly displays concentration in mg/L of free chlorine on the Liquid Crystal Display. INTERFERENCES · Alkalinity: or KEYPAD DESCRIPTION · ON/OFF: to turn the meter on and off. · ZERO/SET: this is a bi-functional key: press to zero the meter prior to measurement, or hold the key for 3 seconds to select the desired parameter ("701" chlorine LOW RANGE or "771" chlorine ULTRA HIGH RANGE). · READ/TIMER: this is a bi-functional key, just press for making a measurement, or hold the key for 3 seconds to start a pre-programmed countdown prior to measurement. · CAL CHECK: this bi-functional key allows to perform validation of the instrument just pressing the CAL CHECK key, or hold the key for 3 seconds to enter the calibration mode. OPERATING MODES · Measurement mode: default operation mode, enables both validation and measurement. [. . . ] The concentration of the sample is beyond the programmed range: dilute the sample and re-run the test. A flashing value lower than the maximum concentration (i. e. "200" for chlorine Ultra High Range 771 or "2. 00" for chlorine Low Range 701) indicates a low signal-to-noise ratio condition. In this case accuracy of the result is not guaranteed. [. . . ]