User manual HANNA INSTRUMENTS HI 322N

[. . . ] Unlike conventional stirrers, all Hanna stirrers use the concept of pulse-driven drive to give the full power required to effectively stir the fluid regardless of the speed. This eliminates the need to start the motor at high speed and the user is now able to control the speed precisely. 3 WARRANTY All Hanna Instruments products are warranted for two years against defects in workmanship and materials when used for their intended purpose and maintained according to the instructions. Damages due to accidents, misuse, tampering or lack of prescribed maintenance are not covered. This warranty is limited to repair or replacement free of charge. [. . . ] Specifications for all models Speed Control ON/OFF and continuously variable with potentiometer knob Direct drive D. C. Unplug the stirrers from the power supply before replacing the fuse. Drive Power 4W Consumption Torque Delivered Power Supply Fuse 85 g·cm 115 or 230 Vac, 50/60 Hz depending on models 400 mA/250 V; 20x5 mm Teflon® coated, L 50 x dia 7 mm ACCESSORIES HI 731320 Magnetic stir bar (10 pcs) Stirring Bar Recommendations for Users Before using these products, make sure that they are entirely suitable for the environment in which they are used. Operation of these instruments in residential area could cause unacceptable interferences to radio and TV equipments, requiring the operator to take all necessary steps to correct interferences. Any variation introduced by the user to the supplied equipment may degrade the instruments' EMC performance. Unplug the stirrers from the power supply before replacing the fuse. To avoid damages or burns, do not place these stirrers in microwave ovens. 6 7 HI 300N & HI 310N GENERAL PURPOSE STIRRERS These general purpose stirrers are suitable for daily stirring applications in the laboratory. HI 300N normal stirrer and HI 310N autospeed stirrer are covered with a corrosion resistant stainless steel top. 1 2 HI 300N Maximum Stirring Capacity HI 310N 2. 5 Liters 5 Liters (0. 66 gallons) (1. 3 gallons) Speed Range Min Max Auto-Speed 100 rpm 800 to 1000 rpm not applicable standard MAGNETIC STIRRER HI 300N POWER ON OFF MAX SPEED Power Supply HI 300N-1 HI 300N-2 HI 310N-1 HI 310N-2 Installation Category Cover Material 110/115 Vac, 50/60 Hz 220/240 Vac, 50/60 Hz 110/115 Vac, 50/60 Hz 220/240 Vac, 50/60 Hz II 1 2 HI 310 AUTOSPEED MAGNETIC STIRRER AISI 316 stainless steel POWER ON OFF MAX Environment SPEED 0 to 50ºC (32 to 122ºF); RH max 95% 180 x 180 x 70 mm (7. 1 x 7. 1 x 2. 8") 1. 4 kg (3. 1 lb. ) Dimensions 1. Power indicator (LED lights up when the stirrer is powered) 2. ON/OFF/SPEED knob, to turn the stirrer ON and OFF, and set the stirring speed (continuously variable up to the maximum) Weight 8 9 HI 301N & HI 311N TWO-SPEED STIRRERS HI 301N normal stirrer and HI 311N autospeed stirrer, are ideal for long duration stirring which require slow speed and accurate speed control (for example in electrolysis applications). The selectable HIGH/LOW range allows to set the speed precisely. Maximum Stirring Capacity Speed Range Low High Auto-Speed 1 2 HI 301N HI 311N 2. 5 Liters 5 Liters (0. 66 gallons) (1. 3 gallons) 100 to 500 rpm 100 to 800/1000 rpm not applicable standard 3 MAGNETIC STIRRER HI 301N HIGH POWER ON OFF MAX SPEED LOW Power Supply HI 301N-1 HI 301N-2 HI 311N-1 HI 311N-2 Installation Category 110/115 Vac, 50/60 Hz 220/240 Vac, 50/60 Hz 110/115 Vac, 50/60 Hz 220/240 Vac, 50/60 Hz II 1 2 3 HI 311 AUTOSPEED MAGNETIC STIRRER HIGH Cover Material Environment AISI 316 stainless steel POWER ON OFF MAX 0 to 50ºC (32 to 122ºF); RH max 95% RH 180 x 180 x 70 mm (7. 1 x 7. 1 x 2. 8") 1. 4 kg (3. 1 lb. ) SPEED LOW Dimensions 1. Power indicator (LED lights up when the stirrer is powered) 2. ON/OFF/SPEED knob, to turn the stirrer ON and OFF, and set the stirring speed (continuously variable up to the maximum) 3. HIGH/LOW switch (for selecting low or high speed range) Weight 10 11 HI 302N & HI 312N AUTO-REVERSE STIRRERS HI 302N normal stirrer and HI 312N autospeed stirrer allow to stir the fluid in both directions and are ideal for powder mixing applications to ensure a homogeneous final product and complete dissolution of hard-to-wet powders. The reverse stirring period is adjustable from 30 seconds to 3 minutes. When set to 1 minute, the fluid will rotate in one direction for minute and then reverse its rotation for another minute at the desired speed in a repeated cycle until the stirrer is switched off. 1 2 3 HI 302N Maximum Stirring Capacity Speed Range Min. Reverse Interval Auto-Speed HI 312N 2. 5 Liters 5 Liters (0. 66 gallons) (1. 3 gallons) 100 rpm 800 to 1000 rpm from 30 seconds to 3 minutes not applicable standard MAGNETIC STIRRER HI 302N ON OFF MAX 0. 5' OFF 3' Power Supply HI 302N-1 HI 302N-2 HI 312N-1 HI 312N-2 Installation Category Cover Material 110/115 Vac, 50/60 Hz 220/240 Vac, 50/60 Hz 110/115 Vac, 50/60 Hz 220/240 Vac, 50/60 Hz II POWER SPEED REVERSE PERIOD 3 1 2 HI 312 AUTOSPEED MAGNETIC STIRRER AISI 316 stainless steel ON OFF MAX 0. 5' OFF Environment 3' POWER 0 to 50ºC (32 to 122ºF) 95% RH max. 180 x 180 x 70 mm (7. 1 x 7. 1 x 2. 8") 1. 4 kg (3. 1 lb. ) SPEED REVERSE PERIOD Dimensions 1. Power indicator (LED lights up when the stirrer is powered) 2. ON/OFF/SPEED knob, to turn the stirrer ON and OFF, and set the stirring speed (continuously variable up to the maximum) 3. REVERSE PERIOD knob with the ON/ OFF and continuously variable selection of inversion cycle time in minutes, from 0. 5 to 3 minutes 12 Weight 13 HI 303N TWO-SPEED STIRRER WITH TACHOMETER HI 303N stirrer incorporates an LCD tachometer. This model allows precise stirring repeatability by using two separate ranges. [. . . ] (03) 3258. 9565 · Fax (03) 3258. 9567 Korea: Tel. (02) 2278. 5147 · Fax (02) 2264. 1729 Malaysia: Tel. (603) 5638. 9940 · Fax (603) 5638. 9829 Singapore: Tel. 6296. 7118 · Fax 6291. 6906 South Africa: Tel. [. . . ]