User manual HARMAN KARDON AVR 146

[. . . ] AVR 146 AUDIO/VIDEO RECEIVER OWNER'S MANUAL SAFETY INFORMATION home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions. This product may be equipped with a polarized alternating-current-line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. [. . . ] SURROUND: Move the cursor to the line for the surround, or rear, speakers, and use the </> Buttons to select a setting for these two speakers. SUBWOOFER: Move the cursor to the line for the subwoofer, which is programmed a little differently. The subwoofer's "size" setting depends upon how you programmed the front left and right speakers. · If you set the front speakers to SMALL, the subwoofer setting will be SUB, and you won't be able to change it. All low-frequency information will always be sent to the subwoofer. If you don't have a subwoofer, you may wish to set your front speakers to LARGE so as not to lose this information, but you may need to lower the volume to avoid adverse results. We recommend that you either upgrade to full-range speakers or add a subwoofer to your system at the earliest opportunity. · If you set the front speakers to LARGE, you may select from three possible settings for the subwoofer. Figure 41 ­ Speaker/Channel Input Indicators BASS MGR: This advanced setting is used if you wish to configure your speakers differently for different sources. For example, you may prefer to set your speakers to LARGE while listening to CDs from your CD player. By changing this setting to INDEPENDENT, you may have different settings for your CD player and your DVD player or other devices. We recommend that you leave this setting at its factory default of GLOBAL until you have more experience with the AVR. Move the cursor to the BACK TO MANUAL SETUP line and press the Set Button to return to the Manual Setup Menu. The speaker sizes may also be configured without using the on-screen menu system. Press the Speaker Setup Button on the remote, and use the //¤ Buttons to select the desired speaker group (Front Speakers, Center Speaker, Surround Speakers, Subwoofer). Press the Set Button to display the current setting for the speaker group, and use the //¤ Buttons again to change the setting. Press the Set Button to return to the previous display, or wait a few seconds for the AVR to return to normal operation on its own. NOTE: The Speaker/Channel Indicators on the front panel of the receiver (see Figure 41) will display the speaker size settings as follows. For each speaker configured as SMALL, a single box will appear in the position for that speaker. For each speaker configured as LARGE, a double box will appear in its position. If a speaker is configured as NONE, no box will appear. The subwoofer will be indicated by a single box, or no box if no subwoofer has been configured. The letters inside the boxes appear when a digital signal is being received that has that channel discretely encoded. [. . . ] Thus, the speaker sizes are always full-range, and it isn't possible to adjust speaker size crossover. Channel levels vary by surround mode rather than source input. 51 51 APPENDIX Table A6 ­ Remote Control Codes Source Input Video 1 Video 2 Video 3 HDMI 1 HDMI 2 DVD CD Tape Product Type (circle one) VCR, PVR Cable, Satellite TV DVD, VCR/PVR, Cable/Satellite DVD, VCR/PVR, Cable/Satellite DVD CD, CDR Cassette Remote Control Code 1 4 8 5 9 11 13 17 21 14 18 6 2 3 7 10 12 15 19 22 23 16 20 Table A7 ­ System Settings Feature VFD Fade Time-Out Volume Default Default Vol Set Semi-OSD Time-Out Full-OSD Time-Out Default Surr Mode OSD Background Default Setting Off Off ­25dB 5 Seconds 20 Seconds On Blue Your Setting 24 28 30 34 38 42 46 50 54 57 60 66 31 35 39 43 47 51 25 27 26 29 32 36 40 44 48 52 55 58 61 67 33 37 41 45 49 53 56 59 62 63 64 65 68 Refer to the numbered buttons in this drawing when using the Function List. Figure 74 ­ Remote Control Function List Reference 52 APPENDIX Table A8 ­ Remote Control Function List No. Button Name 1 Power On 2 Power Off 3 Mute 4 AVR 5 DVD/CD 6 Tape/ The AVR Function Power On Power Off Mute AVR Select DVD Select CD Select TM DVD Power On Power Off Mute AVR Select DVD Select CD Select Tape Select HDMI 1 Select HDMI 2 Select VCR Select CBL/SAT Select TV Select Tuner Select 6/8 Ch. OFF CD/CD-R Power On Power Off Mute AVR Select DVD Select CD Select Tape Select HDMI 1 Select HDMI 2 Select VCR Select TV Select Tuner Select 6/8 Ch. [. . . ]