User manual HARMAN KARDON AVR 25

[. . . ] s Do not place furniture or other heavy objects on the cord, and avoid dropping heavy objects on it. Also do not make a knot in the cord. MOVING THE UNIT Before moving the unit, be sure to unplug the power cord from the AC outlet and disconnect all wires to antennas and other components. TABLE OF CONTENTS Front Panel Controls . . 17 ENGLISH DO NOT OPEN THE CABINET Do not attempt to service this unit. Tampering with internal components can cause fire or shock, and may void your guarantee. [. . . ] CENTER/REAR SPEAKER TERMINALS Connect the center and rear speakers to the corresponding terminals. Make sure that the positive (+ or red) and negative (- or black) terminals on the speakers are connected to the corresponding terminals on the receiver. When you connect the rear speakers, connect both L and R speakers. PLEASE NOTE: Sound will not be provided through the rear speakers unless both speakers are connected. 14. SUBWOOFER OUTPUT JACKS Connect a powered subwoofer to these jacks. This output may also be used for any external component requiring a full range volume level input. 17. AC INPUT CORD Plug this cord in AC outlet on a wall. 15. SPEAKER TERMINALS Connect the front left (L) and right (R) speakers to the corresponding terminals. Make sure that the positive (+ or red) and negative (- or black) terminals on the speakers are connected to the corresponding terminals on the receiver. 18. AC SWITCHED OUTLET These outlets provides AC power. The AC power is switched by the power button of this receiver. The MEMORY indicator will light up for 5 seconds. Select the preset number with the UP or DOWN TUNE/PRESET button or the numeric buttons on the remote while the MEMORY indicator is lit. Press the MEMORY button to store the station. When using the NUMERIC buttons on the remote, the station is stored in memory without pressing the MEMORY button again. When selecting single digit preset numbers with the NUMERIC buttons on the remote, press the corresponding number without pressing "0" first. Repeat steps 1 to 4 to preset other stations. LISTENING TO BROADCASTS Press the AM or FM button and use auto, manual or preset tuning to select a radio station. AUTO TUNING If broadcast signals are strong enough, auto tuning is possible. Press the FM or AM button to select the desired band. Press the Seek Stereo button so that AUTO lights up in the display. Press the UP or DOWN TUNE/PRESET button. Tuning will start automatically and stop at a broadcast station frequency with sufficient signal strength. PRESET TUNING The receiver has a memory for up to 30 preset stations. If the station frequencies are stored in this memory, they can be tuned in by a simplified procedure: 12 AVR10 engelsk 11/01/98 10:10 Side 13 ENGLISH RECALLING THE PRESET STATIONS Select the preset number of the desired preset station with the UP or DOWN TUNE/PRESET (in the PRESET mode) or NUMERIC buttons on the remote control unit. In the event of a power failure or when the receiver is disconnected from the AC outlet, the memorized stations are maintained for approximately 2 weeks. DUBBING FROM VCR2 TO VCR1 1. [. . . ] BATTERY COMPARTMENT This battery case is provided as the power source for the commander. To 5 CD Tuner remove the cover, press it down with your thumb and pull it towards the back side. Two UM-3, size "AA" or R6 1. 5V dry batteries are used. When loading the batteries, make sure that the polarity is correct. [. . . ]