User manual HARMAN KARDON AVR 160

[. . . ] AVR 160 AUDIO/VIDEO RECEIVER OWNER'S MANUAL SAFETY INFORMATION Important Safety InStructIonS 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] When the Speaker Detection test is completed, select the Continue option. The results will be displayed, along with these options: · The Retest option repeats the EzSet/EQ process. Increase the master volume manually, if some speakers were not correctly detected. · Select Cancel to return to the Speaker Setup menu. See the Advanced Functions section for instructions on how to manually configure the speakers or manually adjust the settings established by the EzSet/EQ process. Audio In: If you used a digital audio connection for a source, change this setting to assign the correct digital audio input, even if you also connected its analog audio outputs to the receiver. Move the cursor to this line, and press the M N Buttons until the correct digital input appears. If an analog audio connection was used, change this setting to ANALOG. Auto Poll: The Auto Poll feature is used when both an analog audio and digital audio connection have been made for one source device. If no digital signal is available, the AVR 160 will switch to the analog input for the source. This situation can occur with some cable or satellite television broadcasts, where some channels are broadcast with digital audio and others with analog audio, or when a DVD player is paused or stopped. For some sources, the Auto Poll feature is unnecessary and may be undesirable, such as for a DVD player. Move the cursor to this line, and press the M N Buttons until OFF appears, disabling the Auto Poll feature. With Auto Poll turned off, the receiver will only check for a signal at the audio input assigned to the source. The remaining lines in the Input Setup menu adjust the audio performance, and may be skipped at this time. Leaving these settings at their factory defaults is recommended for most listening, in order to enjoy the sound mix created by your favorite movie and music artists. BXR: Enhances bass performance when playing MP3 tracks. Select ON, or leave at the default OFF setting for non-MP3 audio. Tone: Determines whether the treble and bass controls are active. When it's off, the tone controls are "flat", with no changes. When it's on, the bass and treble frequencies are boosted or cut, depending upon the tone-control settings. When an analog audio source is in use and the 2-Channel Stereo surround mode is selected, setting the Tone to OFF places the unit in analog bypass mode. Bass and Treble: Boost or cut the low or high frequencies by up to 10dB by using the M N Buttons to change the setting by 2dB at a time. Set up Sources The Info Settings menu is used to assign the correct physical audio and video connections to each source. [. . . ] NOTE: A system reset erases all user configurations, including video resolution, speaker and level settings, and tuner presets. After a reset, reenter all of these settings from your notes in the appendix worksheets. To reset the AVR 160, place it in Standby mode (press the front-panel Standby/On Switch so that the Power Indicator turns amber). Mode Button until the RESET message appears. If the receiver does not function correctly after a processor reset, contact an authorized Harman Kardon service center for assistance. [. . . ]