User manual HARMAN KARDON CDR 30

[. . . ] CDR 30 CD Recorder OWNER'S MANUAL CDR 30 STOP PLAY PAUSE PROGRAM PREV. NEXT DUAL DISPLAY Record Sync Rec. 1 Trk. Dub Dubbing Speed Erase Finalize DISPLAY I Power Phones Phones Level ® Power for the digital revolutionTM Table of Contents 3 3 3 4 5 7 9 10 12 14 14 14 14 15 15 15 16 16 17 17 17 17 18 18 18 18 19 19 19 19 20 20 21 21 22 23 23 24 24 25 26 Introduction Special Features Important Information on CD Recording Safety Information Front Panel Controls Front Panel Information Display Rear Panel Connections Remote Control Functions Installation and Connections CD Recording Basics Disc Types Recording Options CDR Terminology and Display Messages Playback Basics Loading and Unloading Discs Using the Remote Normal Play MP3 Playback HDCD® Playback CD Text Playback Search Track Skip Dual-Play Mode Two-Disc Changer Operation Time Display Headphone Listening Program Play Programming Play Lists Checking, Editing and Clearing Programmed Play Lists Repeat Play Random Play Intro Scan CD Recording Disc Dubbing Recording from an External Source Sync Recording Record Levels Finalizing CD-R and CD-RW Discs Unfinalizing and Erasing CD-RW Discs Troubleshooting Guide and Error Messages Technical Specifications Declaration of Conformity We, Harman Consumer International 2, Route de Tours 72500 Château-du-Loir, FRANCE declare in own responsibility, that the product described in this owner's manual is in compliance with technical standards: EN 60065:1993 EN 55013/A12/8. 1994 EN 55022/5. 1995 EN 55020/12. 1994 EN 61000-3-2/4. 1995 EN 61000-3-3/1. 1995 Carsten Olesen Harman Consumer International 01/01 Typographical Conventions In order to help you use this manual with the remote control, front panel controls and rear panel connections, certain conventions have been used. EXAMPLE ­ (bold type) indicates a specific remote control or front panel button, or rear panel connection jack or a lit indicator in the front panel information display. EXAMPLE ­ (OCR type) indicates a message that is visible on the front-panel information display 1 ­ (number in a square) indicates a specific front panel control 0 ­ (number in an oval) indicates a button or indicator on the remote ¡ ­ (number in a circle) indicates a rear-panel connection A ­ (letter in a square) indicates an indicator in the front-panel display HDCD®, High Definition Compatible Digital® and Pacific MicrosonicsTM are either registered trademarks or trademarks of Pacific Microsonics, Inc. , in the United States and/or other countries. [. . . ] If you attempt to play an unfinalized disc in the Play Deck 3, a DISC ERROR message will appear to remind you to play the disc in the other deck. To go directly to a specific track on a disc, enter the track number using the Numeric Keys E. Note that when selecting a two-digit track number, the second digit must be entered within three seconds after the first Numeric Key is pressed. To play the track selected press the Play/Select button (9. To momentarily stop the disc at any time, press the Pause button LÔZ. When a disc is paused, the Play/Pause Indicator L will add two vertical lines to indicate a paused disc. Press either the Play button 9(a or the Pause button LÔZ to resume playback at the point where the disc was paused. When there is only one disc in the unit, it will automatically stop when all tracks on a disc have played through. To stop playback at any time, press the Stop button KÓb for the deck in use. When there is a disc in each deck, the player will respond in one of two ways, depending on which dual-play setting is activated. In normal operation (Single-Play Indicator D is lit), when the disc in one drawer finishes, the disc in the other drawer will begin to play. When the Dual button N¸ is pressed so that the Dual-Play Indicator D is lit, each deck will operate as a separate, single-play CD unit without regard to the status of the other deck. For complete information on Dual-Deck and DualPlay operation, see page 18. At the end of a listening session, remove the discs from the decks by following the instructions shown on the previous page. Do not leave the disc drawers open when the unit is not in use to prevent dust and dirt from entering the unit and to prevent damage to the tray. To place the unit in a Standby mode at the end of a listening session, press the Power-Off button S. The word POWER OFF will appear briefly in the Time/Message Display F, any open disc trays will automatically close, and the Status-Mode Indicator 2 will turn orange. MP3 Playback The CDR 30 is unique among consumer audio CDR/RW recorders in that it plays discs recorded with MP3 data. It may also make conventional CD Audio copies of these discs when they are dubbed using the CDR 30's dual-deck capabilities. Since MP3 discs may appear in two different forms, their playback may require different operation. When a disc has been recorded ONLY with MP3 data, simply insert the disc in the CDR 30 as you would for any CD. After the disc's Table of Contents (TOC) data has been read, the MP3 Indicator P will light to indicate that an MP3 disc is in use. [. . . ] When ERASE goes out, the Time/Message Display F will show the total number of tracks that now remain on the disc (under the Track Indicator W) and the total running time of all tracks. Erasing Several Tracks You may erase more than one track, counting backwards from the last track. Note that the Time/Message Display F will display 01 TRK and ERASE will flash. Within 3 seconds press the Next Button MÛ or Previous Button 8Ù until the number of tracks to be erased appears in the Time/Message Display F. [. . . ]