User manual HARMAN KARDON FL8370

[. . . ] 250 Crossways Park Drive, Woodbury, New York 11797 www. harmankardon. com © 1999 Harman Kardon, Incorporated YIAR-J1000-ZZA FL 8370 Compact Disc Changer OWNER'S MANUAL FL 8370 1 4 2 5 Power Phones Phones Level Time Repeat Intro Clear Program ® Power for the digital revolution. TM FL 8370 Compact Disc Changer 3 4 4 5 7 8 9 10 10 11 11 11 11 11 11 12 12 12 12 13 13 13 13 13 14 15 Introduction Safety Information Unpacking Front-Panel Controls Rear-Panel Connections Remote Control Functions Installation and Connections Operation Loading Discs Normal Play Random Play HDCD® Play Exchange Time Display Headphone Listening Search Functions Search Skip Intro Search Programmed-Play Operation Programmed Play Checking Program Contents Clearing Programs Repeat Play Troubleshooting Guide Technical Specifications Typographical Conventions In order to help you use this manual with the remote control, front-panel controls and rear-panel connections, certain conventions have been used. EXAMPLE ­ (bold type) indicates a specific remote control or front-panel button, or rear-panel connection jack EXAMPLE ­ (OCR type) indicates a message that is visible on the front-panel information display EXAMPLE ­ (outlined type) indicates a lit indicator in the front-panel information display 1 ­ (number in a square) indicates a specific front-panel control a ­ (number in an oval) indicates a button or indicator on the remote ¡ ­ (number in a circle) indicates a rear-panel connection 2 TABLE OF CONTENTS Introduction Thank you for choosing Harman Kardon. The FL 8370 CD changer is an exceptionally well-engineered product that offers high performance and ease of use. We ask that you take a few minutes to read through this Owner's Manual to familiarize yourself with its controls and functions. [. . . ] You may also use the IR Sensor in the FL 8370 to send commands to other compatible remote controlled products. Connect the Remote IR-Out jack £ to the input of the other product or system. Connect the power to a nonswitched AC wall outlet or to the accessory outlet on the rear of another audio device in your system and you are ready to go!NOTE: When using the accessory outlet on another product to power the FL 8370 make certain that it has the compatibility to power a device that draws at least 20 watts of current in addition to being able to handle the requirements of the other devices that may be plugged into the accessory outlets. If you use a "switched" outlet, it is important to remember that the host product must be turned on in order for the FL 8370 to operate. © Install the two AA batteries supplied with the FL 8370's remote by turning the remote over so that you are holding the bottom side up. Press lightly on the embossed arrow on the cover and gently slide the cover towards you in the direction of the arrow. Insert the batteries inside the compartment, being careful to follow the + and ­ polarity indications at the bottom of the compartment. Replace the cover by placing it on the remote and sliding it back towards the top of the remote. 9 INSTALLATION AND CONNECTIONS Operation Loading Discs To load a disc, first turn the FL 8370 on, using the Power Switch 1. Note that the StatusMode Indicator 2 will turn green and the Information Display Ó will illuminate. The word disc will flash in the Information Display, and the disc tray will automatically turn clockwise so that the FL 8370 can sense which, if any, of the disc positions already have a disc. To load a disc, first press the Open/Close button !, taking care to make certain that the space in front of the drawer is not obstructed. Note that if the drawer is blocked when you attempt to open it, it will automatically close within five seconds to protect the mechanism. Load discs in the tray with the printed (label) side facing up toward you. Make certain that the disc is centered in the tray. Either 5" (12cm) or 3" (8cm) discs may be used. When a 3" (8cm) disc is played, it should be carefully centered within the smaller ridges on the tray. Only one CD can be placed in any position at a time. When a 3" (8cm) disc is played, DO NOT place a standard 5" (12cm) disc over the smaller disc. Labeled surface Note that each disc position has a number embossed in the plastic tray. This corresponds to the position this disc will occupy for playback and programming. To make it easier to identify each disc's position, the disc position number for the holder space that is in the center of the disc tray will also appear in the Information Display when the disc drawer is open. To rotate the disc tray to another position, press the Disc-Skip button * n. The tray will revolve to the next slot and the Information Display will indicate the position number for the slot in the middle of the tray. [. . . ] NOTE: You may cancel a repeat function any time by pressing the Repeat button 7 m until the R E P E AT indicators go out. The player will continue with normal play and then stop when the current disc is finished playing. Programmed Play Programmed play allows you to program up to 32 tracks into the FL 8370's memory. To begin programming the FL 8370, press the Program button ) j. The P R O G R A M indicator will light in the Information Display Ó. [. . . ]