User manual HARMAN KARDON HD 755

[. . . ] HD 755 CD Player OWNER'S MANUAL HD 755 Power for the Digital Revolution® Table of Contents 2 3 4 4 5 6 7 9 10 10 10 11 11 11 11 12 12 12 13 13 13 13 14 15 16 Typographic Conventions Introduction Information Unpacking Front Panel Controls Rear Panel Connections Remote Control Functions Installation Operation Loading and Unloading Discs Normal Play HDCD® Discs Play Headphone Listening Display Dim Time Display Search Skip Intro Search Programmed Play Operation Programmed Play Checking Program Contents Clearing Programs Repeat Play Troubleshooting Guide Technical Specifications Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Château-du-Loir, FRANCE declare in own responsibility, that the product described in this owner's manual is in compliance with technical standards: EN 60065:1993 EN 55013/A12/8. 1994 EN 55022/5. 1995 EN 55020/12. 1994 EN 61000-3-2/4. 1995 EN 61000-3-3/1. 1995 Carsten Olesen Harman Kardon Europe 01/04 Typographic Conventions In order to help you use this manual with the remote control, front panel controls and rear panel connections, certain conventions have been used. EXAMPLE ­ (bold type) indicates a specific remote control or front panel button, or rear panel connection jack. EXAMPLE ­ (bold type) indicates a message in the front panel information display. 1 ­ (number in a square) indicates a specific front panel control. [. . . ] When the unit is turned off (to Standby), pressing any button on the front panel will turn the unit on. When Play button 4 9 on the front or on the remote is pressed, the unit will automatically turn on and start playing the disc actually loaded. Load the disc in the tray with the printed (label) side facing up. Make certain that the disc is centered in the tray. Either 12cm (5") or 8cm (3") discs may be used. When an 8cm disc is played, it should be carefully centered within the smaller ridges inside the cassette drawer. To remove a disc from the player, press the Open/Close button $ F. The drawer will open, allowing the disc to be removed. Disc Handling Notes When loading or unloading discs, it is best to hold them by the edges. While Compact Discs are very reliable, rough handling may damage them. Avoid scratching the bottom (non-printed) side of discs, or any handling which will leave fingerprints. To avoid damage to the disc and player, always seat discs so that they are centered in the tray. Do not lift the player while the disc tray is opening or closing, as this may cause the disc to unseat from the tray and possibly jam. Pressing the Open/Close button once a disc has been carefully seated will close the disc drawer while the message CLOSING will appear in the information display. As soon as the tray is closed the display will show the message TRACKING while the table of content (TOC) of the disc is read. Note that particulary with CD-RW discs this tracking may take some time due to the reflectibility and data structure different from normal discs. Afterwards the Information Display will show the total number of tracks on a disc and the total running time of the disc. TRACK MIN SEC Normal Play To play a disc, first turn the HD 755 on using the Power Switch 1 on the front panel or the Power On button 1 on the remote control. When the unit is turned off (to Standby), pressing any button on the front panel will turn the unit on. When Play button 4 9 on the front or on the remote is pressed, the unit will automatically turn on and start playing the disc actually loaded. To load or change a disc open the disc drawer by pressing the Open/Close button $ F. Place a disc in the tray following the instructions shown above. The drawer will also close when the Play button 4 9 is pressed. The drawer will close and the disc will start playing the first track. [. . . ] To program the unit for A­B play, first locate the point on the disc where you wish to begin the repeated section. At that point, press the Repeat A­B button 6. The REPEAT indicators will light in the Information Display and an A­ indicator to show that the program process has started. Let the disc continue to play or press the Search -- button 6 8 or Skip fl· button 7 7 on the front or remote until you have reached the end of the section to be repeated. [. . . ]