User manual HARMAN KARDON HD200

[. . . ] EXAMPLE ­ (bold type) indicates a message in the front panel information display. 1 ­ (number in a square) indicates a specific front panel control. a ­ (number in an oval) indicates a button or indicator on the remote. ¡ ­ (number in a circle) indicates a rear panel connection. 2 TABLE OF CONTENS 30525_HD_950_Eng 20/10/06 8:58 Side 3 Introduction Thank you for choosing Harman Kardon HD 950 CD player. [. . . ] ENGLISH INSTALLATION 9 30525_HD_950_Eng 20/10/06 8:58 Side 10 Operation Loading and Unloading Discs To load a disc, first turn the unit on (if not so already) by pressing the Power Switch 2 on the front panel or the Power On button 1 on the remote, then press the Open/Close button 3 F taking care to make certain that the space in front of the drawer is not obstructed. When the unit is turned off (to Standby), pressing the Play button 4 9 on the front or on the remote will automatically turn on the CD player and start playback. Load the disc in the tray with the printed (label) side facing up. Make certain that the disc is centered in the tray. Either 12cm (5") or 8cm (3") discs may be used. When an 8cm disc is played, it should be carefully centered within the smaller ridges inside the cassette drawer. To remove a disc from the player, press the Open/Close button 3 F. The drawer will open, allowing the disc to be removed. Disc Handling Notes When loading or unloading discs, it is best to hold them by the edges. While Compact Discs are very reliable, rough handling may damage them. Avoid scratching the bottom (non-printed) side of discs, or any handling which will leave fingerprints. The drawer will also close when the Play button 4 9 is pressed. The drawer will close and the disc will start playing the first track. 10 OPERATION 30525_HD_950_Eng 20/10/06 8:58 Side 11 Operation While the disc is playing, the track being played will show as a number in the middle of the display just below the word TRACK. The elapsed time of the track being played will also appear in the display (see figure page 10). As a disc plays, the track numbers will change, and the time will reset to at the start of each new track. To momentarily pause the play of a disc, press the Pause button 5 9. Note that a Pause indication ± will appear in the display to remind you that the disc is paused. Press either the Play button 4 9 or the Pause button 5 9 to resume normal play. To stop the disc, press the Stop button 6 A. When the Stop button is pressed the display again will show the total number of tracks and total running time of the disc. To remove a disc from the player, press the Open/Close button 3F. To prevent dirt and dust from entering the unit, do not leave the disc tray open. [. . . ] If the track is changed by pressing the Skip buttons 7 8 7 while the Repeat function is in use, the newly selected track will be played normally. To stop the repeat play, press the Stop button 6 A or press the Repeat button 5 until the REPEAT indicator goes out. Repeat All Tracks To repeat all of the tracks on a disc during play mode, press the Repeat button 5 until the REPEAT and ALL indicators light up. When you see these indicators, the entire disc or all programmed tracks will play through to the end, and then start again from the beginning. [. . . ]