User manual HARMAN KARDON HD500

[. . . ] , HDCD®, High Definition Compatible Digital® and Pacific MicrosonicsTM are either registered trademarks or trademarks of Pacific Microsonics, inc. , in the United States and/or other countries. HDCD System manufactured under license from Pacific Microsonics, Inc. 1) ® 250 Crossways Park Drive, Woodbury, New York 11797 www. harmankardon. com Harman Consumer International: 2, route de Tours, 72500 Château-du-Loir, France © 1999 Harman Kardon, Incorporated Part #3828SND043A HD750 CD Player OWNER'S MANUAL ® Power for the Digital RevolutionTM Table of Contents 2 3 4 4 5 6 7 9 10 10 10 11 11 11 11 12 12 12 13 13 13 13 14 15 16 Typographic Conventions Introduction Information Unpacking Front Panel Controls Rear Panel Connections Remote Control Functions Installation Operation Loading and Unloading Discs Normal Play HDCD® Discs Play Headphone Listening Display Dim Time Display Search Skip Intro Search Programmed Play Operation Programmed Play Checking Program Contents Clearing Programs Repeat Play Troubleshooting Guide Technical Specifications Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Château-du-Loir, FRANCE declare in own responsibility, that the product described in this owner's manual is in compliance with technical standards: EN 60065:1993 EN 55013/A12/8. 1994 EN 55022/5. 1995 EN 55020/12. 1994 EN 61000-3-2/4. 1995 EN 61000-3-3/1. 1995 Carsten Olesen Harman Kardon Europe 09/00 Typographic Conventions In order to help you use this manual with the remote control, front panel controls and rear panel connections, certain conventions have been used. EXAMPLE ­ (bold type) indicates a specific remote control or front panel button, or rear panel connection jack. EXAMPLE ­ (bold type) indicates a message in the front panel information display. [. . . ] Make certain to use a coaxial-style interconnect cable, as standard audio cables will not perform as well. Install two AA batteries by turning the remote over so that you are holding the bottom side up. Press lightly on the embossed arrow on the cover and gently slide the cover towards you in the direction of the arrow. Insert the batteries inside the compartment, being careful to follow the + and ­ polarity indications at the bottom of the compartment. Replace the cover by placing it on the remote and sliding it back towards the top of the remote. NOTE: When replacing batteries, always replace both at the same time. When the unit will not be used for an extended period of time, it is also a good idea to remove the batteries so that the potential for corrosion or damage is avoided. If the HD750 is installed behind a cabinet or other obstruction that may block the path between the front-panel Remote Sensor 3 and the location of the remote, an optional external IR sensor may be used. Connect the sensor to the Remote IR-In Jack £ on the rear panel. This jack may also be connected to the IR-Output jack of another compatible Harman Kardon component or a compatible IRsystem- remote product. You may also use the IR Sensor in the HD750 to send commands to other compatible remote controlled products. When Play button 4 9 on the front or on the remote is pressed, the unit will automatically turn on and start playing the disc actually loaded. To load or change a disc open the disc drawer by pressing the Open/Close button $ F. Place a disc in the tray following the instructions shown above. The drawer will also close when the Play button 4 9 is pressed. The drawer will close and the disc will start playing the first track. To play all of the tracks on the disc in order, press the Play button 4 9. A play indication fl will appear in the Information Display %. To play all of the tracks in random order, press the Random button ) C and then the Play button 4 9. The RANDOM indicator will light when that mode is in use. Random can be activated also while a track is playing. When Random is activated while programmed play is in use (see page 13), all programmed tracks will be played in random order. . You may also select a specific track by pressing the Skip buttons 7 7 until the wished track number is displayed (see page 12). [. . . ] When the unit is in Stop mode, press Repeat once, select the track to be repeated with the Skip or Numeric buttons as described on page 10, and press Play 4 9. The REPEAT and 1 indicators will light and the track will continue to play over and over again continuously. If the track is changed by pressing the Skip buttons 7 7 while the Repeat function is in use, the newly selected track will be repeated. To stop the repeat play, press the Stop button 5 A or press the Repeat button $ 5 until the REPEAT indicator goes out. Repeat All Tracks To repeat all of the tracks on a disc, press the Repeat button 5 $ until the REPEAT and ALL indicators light up. [. . . ]