User manual HARMAN KARDON HD720

[. . . ] Harman Kardon HD720 Compact Disc Player Open/Close TRACK MIN SEC TOTAL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 OVER > Display Program Random p/Clear Pause Search Skip Phones Level Phones Time Program Repeat Check Owner's Manual Staple or clip original invoice here. w Owner's Manual HD720 Compact Disc Player Table of Contents Introduction . 16 250 Crossways Park Drive Woodbury, NY 11797 ©1998 Harman Kardon, Incorporated Introduction 1 Thank you for choosing the Harman Kardon HD720 CD player. The HD720 is an exceptionally well-engineered product that offers high performance and ease of use. [. . . ] Press the button again to defeat the function and continue full play of the current track. (See page 12 for more information. ) q Display Button: Press this button once to dim the front panel display to half brightness. Press it again to turn the display lights off completely. Another press will return the display to normal brightness. Installation 9 To prevent possible damage to your speakers and other components in your audio system, it is important that ALL components, including the HD720 and receivers are turned off and unplugged from their AC power source when installing any new component. Connecting the HD720 to your audio system is simple. Using standard RCAto-RCA interconnect cords, connect the left and right Fixed Audio Output jacks TM on the rear panel to the CD input jacks on your receiver, surround processor or preamplifier. If your system includes an optional, external digital-to-analog converter, or if you are using a receiver or other processor that has the capability to decode PCM digital input signals, connect the Coaxial Digital Output jack ¡ to the Datastream Digital input on the decoder. Make certain to use a coaxialstyle interconnect cable, as standard audio cables will not perform as well. Install the two AA batteries supplied with the HD720's remote by turning the remote over so that you are holding the bottom side up. Press lightly on the embossed arrow on the cover, and gently slide the cover towards you in the direction of the arrow. Insert the batteries inside the compartment, being careful to follow the + and ­ polarity indications at the bottom of the compartment. Replace the cover by placing it on the remote and sliding it back towards the top of the remote. NOTE: When replacing batteries it is always a good idea to replace both at the same time. When the unit will not be used for an extended period of time, it is also a good idea to remove the batteries so that the potential for corrosion or damage is avoided. Connect the power to a non-switched AC wall outlet, or to the accessory outlet on the rear of another audio device in your system and you are ready to go!NOTE: When using the accessory outlet on another product to power the HD720 make certain that it has the ability to power a device that draws at least 14 watts of current in addition to the requirements of other devices that may be plugged into the accessory outlets. If you use a "switched" outlet, it is important to remember that the host product must be turned on in order for the HD720 to operate. Operation 10 Normal Play To play a disc, first turn the HD720 on using the Main Power Switch 1. If the unit has previously been turned on with the Main Power Switch, but then turned off using the remote control, the Status Mode Indicator 2 will glow amber. In that case, the HD720 may be turned on using the Power On button b on the remote control. To load a disc, first press the Open/Close button &, taking care to make certain that the space in front of the drawer is not obstructed. Note that if the drawer is blocked when attempting to open it, it will automatically close within five seconds to protect the mechanism. Load the disc in the tray with the printed (label) side facing up. Make certain that the disc is centered in the tray. [. . . ] If the track is changed by pressing the Skip buttons 8 h while the Repeat function is in use, the newly selected track will be repeated. To stop the repeat play, press the Stop button 5 k or press the Repeat button $ f until the REPEAT indicator goes out. Repeat A­B The HD720 may be programmed to repeat any section within a track, or a complete passage or program that includes material in a series of tracks. To program the unit for A­B play, first locate the point on the disc where you wish to begin the repeated section. [. . . ]