User manual HARMAN KARDON HD7325

[. . . ] a ­ (number in an oval) indicates a button or indicator on the remote. ¡ ­ (number in a circle) indicates a rear panel connection. 2 TABLE OF CONTENS Introduction Thank you for choosing Harman Kardon HD7325 CD player. The HD7325 is an exceptionally well-engineered product that offers high performance and ease of use. Along with conventional CD audio discs, the HD7325 is also compatible with MP3 data from CDs and most recordable CD formats. [. . . ] Load the disc in the tray with the printed (label) side facing up. Make certain that the disc is centered in the tray. Either 12cm (5") or 8cm (3") discs may be used. When an 8cm disc is played, it should be carefully centered within the smaller ridges inside the cassette drawer. To remove a disc from the player, press the Open/Close button 3 F. The drawer will open, allowing the disc to be removed. Disc Handling Notes When loading or unloading discs, it is best to hold them by the edges. While Compact Discs are very reliable, rough handling may damage them. Avoid scratching the bottom (non-printed) side of discs, or any handling which will leave fingerprints. To avoid damage to the disc and player, always seat discs so that they are centered in the tray. Do not lift the player while the disc tray is opening or closing, as this may cause the disc to unseat from the tray and possibly jam. The elapsed time of the track being played will also appear in the display (see figure page 10). As a disc plays, the track numbers will change, and the time will reset to at the start of each new track. To momentarily pause the play of a disc, press the Pause button 5 9. Note that a Pause indication ± will appear in the display to remind you that the disc is paused. Press either the Play button 4 9 or the Pause button 5 9 to resume normal play. To stop the disc, press the Stop button 6 A. When the Stop button is pressed the display again will show the total number of tracks and total running time of the disc. To remove a disc from the player, press the Open/Close button 3F. To prevent dirt and dust from entering the unit, do not leave the disc tray open. To place the unit in a Standby mode, press the Power Switch 2 on the front panel or the Power Off button 0 on the remote. The display will show a STANDBY message for a moment and the Status Mode Indicator will glow orange, indicating that the unit is off, but ready to accept a Power On command from the remote. [. . . ] If the track is changed by pressing the Skip buttons 7 8 7 while the Repeat function is in use, the newly selected track will be played normally. To stop the repeat play, press the Stop button 6 A or press the Repeat button 5 until the REPEAT indicator goes out. Repeat All Tracks To repeat all of the tracks on a disc during play mode, press the Repeat button 5 until the REPEAT and ALL indicators light up. When you see these indicators, the entire disc or all programmed tracks will play through to the end, and then start again from the beginning. [. . . ]