User manual HARMAN KARDON HK 3375

[. . . ] ® Power for the Digital Revolution. ® HK 3375 STEREO RECEIVER OWNER'S MANUAL 3375 MUTE T-MON AUTO TUNED ST MEMORY PRESET SLEEP HK 3375 STEREO RECEIVER 3 3 4 5 7 8 10 12 14 14 14 14 15 15 15 16 17 Introduction Safety Information Unpacking Front-Panel Controls Front-Panel Information Display Rear-Panel Connections Remote Control Functions Installation and Connections Operation Basic Operation Source Selection Tuner Operation Tape Recording Memory Backup Processor Reset Troubleshooting Guide Technical Specifications Typographical Conventions In order to help you use this manual with the remote control, front-panel controls and rear-panel connections, certain conventions have been used. EXAMPLE ­ (bold type) indicates a specific remote control or front-panel button, or rear-panel connection jack EXAMPLE ­ (OCR type) indicates a message that is visible on the front-panel information display EXAMPLE ­ (outlined type) indicates a lit indicator in the front-panel information display 1 ­ (number in a square) indicates a specific front-panel control å ­ (letter in a circle) indicates a button or indicator on the remote See trademark acknowledgements on page 17. ¡ ­ (number in a circle) indicates a rear-panel connection 2 TABLE OF CONTENTS INTRODUCTION Congratulations!With your purchase of the Harman Kardon® HK 3375 you are about to begin many years of listening enjoyment. [. . . ] After a few seconds, the tuner will start to "look" for active stations, as shown by increasing frequency numbers in the Information Display. Release the button and note that the tuner will briefly stop at each active station and add a preset number to the memory. If the FM tuner finds fewer than 30 FM stations with acceptable signal strength, the Auto Preset tuning will scan two more cycles or until the remaining vacant preset memory spaces have been filled with those found in the first scan. The scan will stop when all 30 preset memory spaces have been filled or when three scans through the band have been completed. µ Secondary Control Cover: This sliding cover normally is in the "up" position so that it hides the secondary controls. To access these controls, place your thumb on the small recessed area at the top center of the control, and gently press the cover down and toward you. Ñ Clear Button: This button is used to clear preset memory information for the HK 3375's tuner. (See page 15 for more information on tuner presets. ) ø Memory Button: Press this button to open a memory position that stores a preset location for the HK 3375's tuner. (See page 15 for more information on tuner presets. ) Master Volume: Press these buttons to raise or lower the HK 3375's volume. oe Preset Scan Button: Press this button to automatically scan through the list of stations that are programmed into the HK 3375's tuner memory. When the button is pressed, each preset station will play for five seconds before the next station is selected. Press the button again when the desired station is heard, to stop the preset scan. ® Mute Button: Press this button to momentarily silence the HK 3375. ß FM Mode Button: Press this button when the tuner is in use in the FM band to switch to monaural reception if the station is weak and noisy. (See page 14 for more information. ) Tuning Up/Down: When the tuner is in use, these buttons will tune up or down through the selected frequency band. A brief (1/2-second) press of the button will manually tune to the next frequency increment, while pressing and holding the button for a longer period will automatically tune to the next station with a signal strong enough for acceptable reception. These buttons will also control Fast Forward and Fast Reverse (or Rewind) for compatible Harman Kardon compact disc players/changers and cassette tape decks. Ü Speaker 1 Selector: Press this button to turn the speakers connected to the Speaker 1 Output Terminals on or off. Speaker 2 Selector: Press this button to turn the speakers connected to the Speaker 2 Output Terminals ° on or off. Transmitter Window: Point this area of the remote toward the receiver when using the remote. Dimmer Button: Press this button once to reduce the brightness of the Information Display Û to half the normal intensity. Press it again to turn the front-panel display completely off. When the display is completely off, press the button to return to normal brightness. î Tuning: Press these buttons to tune up or down through a selected frequency band. [. . . ] To correct this problem, first unplug the unit from the AC wall outlet and wait at least three minutes. After the pause, reconnect the AC power cord and check the unit's operation. If the system still malfunctions, a system reset may clear the problem. If the system still does not respond, it may be necessary to perform a complete reset. [. . . ]