User manual HARMAN KARDON HK12 Product Brochure

[. . . ] BALANCE CONTROL This control is used for balancing the relative sound volume of the left and right channel speakers. Clockwise rotation reduces the volume from the left speaker, counterclockwise rotation reduces the volume from the right speaker. 8. TAPE MONITOR BUTTON Press this button to select input from a tape deck. 9. TUNE / PRESET BUTTON When AUTO is not lit, the TUNE/PRESET buttons will allow you to tune to a station manually. 2. [. . . ] DISPLAY WINDOW This window shows the state of operation for easier control of the receiver. It also contains the IR Remote Sensor. 7. INPUT FUNCTION SELECTOR BUTTONS Press these buttons to select the desired input source. 4 HK12 engelsk 11/01/98 14:28 Side 5 Rear Panel Connections 1 FRONT SPEAKERS ENGLISH FM OUTDOOR ANTENNA AM LOOP ANTENNA FM INDOOR ANTENNA RIGHT LEFT + + 3 1 2 ANTENNA 15 13 300/75 ADAPTOR 300/75 ADAPTOR AC INPUT AC 230V 50Hz AM LOOP PREOUT LEFT RIGHT RIGHT SPEAKERS LEFT SERIAL NO. FM 75 9 VCR 1 LEFT 12 1 16 14 MODEL NO. : HK 3250 HARMAN KARDON NORTHRIDGE CALIFORNIA U. S. A. REMOTE CONTROL IN 2 AC OUTLETS SWITCHED 230V~50Hz 100W MAX RIGHT TV/AUX CD PLAY REC PLAY REC OUT RIGHT LEFT TAPE MON (USE 4 OHM MIN SPEAKERS) AMPLIFIER 10 + + 4 COMPACT DISC PLAYER 8 5 6 7 AUDIO 11 TO 16 CASSETTE DECK IN REC IN PLAY OUT OUT RIGHT 2 FRONT SPEAKERS VCR LEFT TO WALL OUTLET 5 HK12 engelsk 11/01/98 14:28 Side 6 Rear Panel Connections 1. FM INDOOR ANTENNA Connect the supplied antenna (the wire lead) to a 300/75 adapter and connect the adapter to the 75 FM antenna terminal, as shown in the Rear Panel Connection Diagram. Change the position of the antenna until you get the best reception of your favorite stations. When this unit is mounted in a rack or placed on a shelf with sufficient space behind, hang the antenna on a wall in the direction which gives the best reception. NOTE: If noise is heard during AM reception, move the antenna for better reception. To prevent undesired noise, the AM LOOP ANTENNA should be located away from the remote control cord over 12 inches (30cm). 6. TAPE PLAY JACKS Connect the line output of your CASSETTE DECK to these jacks. 12. REMOTE CONTROL IN JACK Connect a Harman Kardon HE 1000 remote I. R. You can operate the unit by remote commander through the adaptor. The AC power is switched by the power button. Use this outlet for a CD player or a cassette deck. PLEASE NOTE: Do not plug irons or toasters or other products with high power consumption into these outlets. LEG Stand and place it on a shelf or hang it on a wall. 6 HK12 engelsk 11/01/98 14:28 Side 7 Operation BASIC OPERATION 1 Press the POWER button to turn the power ON, the display panel will then light up. · When using the POWER button on the remote control turn the unit off, the unit will go into STANDBY mode. 2 Select the desired program source with the INPUT FUNCTION SELECTOR buttons and the selected input function appears in the display. 3 When the TAPE MONITOR button is set to ON so that the TAPE indicator lights up, the selected program source cannot be heard from the speakers. To listen to a program source other than cassette deck be sure to set the TAPE MONITOR button to OFF. 4 Adjust the volume to a comfortable listening level with the VOLUME control or VOLUME UP/DOWN buttons on the remote control. 5 For private listening, insert a 1/4 inch plug of the headphone into the HEADPHONE jack. · When the headphones are plugged, sound from the speakers is cut off. MANUAL TUNING Auto tuning may be impossible if the broadcast signal is weak. 1 Press the FM or AM button to select the desired band. [. . . ] INPUT FUNCTION SELECTOR Press the button to select the desired input function. The available buttons are CD, TUNER, TAPE MON, TV / AUX, VCR 1, and VCR 2. The display will dim when the sleep function has been set. 12. MUTE BUTTON Press this button to silence the speakers temporarily. Press again to restore the same listening level as before. 3. [. . . ]