User manual HARMAN KARDON HK1500

[. . . ] Place the speaker system on a stable, level surface. Do not drop, apply excessive force to the controls, or put heavy objects on top of the speaker. If cleaning is required, use a soft dry cloth. If necessary, use a damp cloth without any solvents. [. . . ] The system includes two desktop speakers and a subwoofer that can be placed either on the floor or on your desk. Both satellite speakers and the subwoofer are magnetically shielded to provide the greatest protection against computer monitor image distortion. file:///D|/HK1500/intro. htm (1 of 2)11/16/2004 3:52:48 AM Introduction:Using the speaker system: harman/kardon Champagne HK1500 Audio System Back to Contents Page file:///D|/HK1500/intro. htm (2 of 2)11/16/2004 3:52:48 AM Setup: harman/kardon HK1500 Audio System Back to Contents Page Setup: harman/kardon HK1500 Audio System Unpacking the speakers · Connecting the speakers to your sound card · Placement of speakers Unpacking the speakers Carefully unpack your speaker system and identify all components: q q q Control/Right Satellite speaker Auxiliary/Left Satellite speaker Subwoofer with attached power and audio input cables Connect the speaker system as shown in the Connecting the speaker system to sound card illustrations. Once the speaker system is properly connected, turn on the power switch located on the rear of the subwoofer. Back to top file:///D|/HK1500/setup. htm (1 of 7)11/16/2004 3:52:52 AM Setup: harman/kardon HK1500 Audio System Connecting the speaker system to the computer. Step 1 If you have an integrated sound solution; or a stereo sound card, connect the green connector from the subwoofer into the green jack on the computer, the black connector is not used, leave the rubber cap on the black connector to prevent static from the pin grounding on the system. If you have a multi-channel sound card; connect the green connector from the subwoofer into the green jack on the computer and connect the black connector from the speaker into the black jack on the computer. If you have a portable computer; connect the green connector from the subwoofer into the headphone jack on the computer, the black connector is not used, leave the rubber cap on the black connector to prevent static from the pin grounding on the system. Step 2 Plug the orange connector from the right/control satellite into the orange jack on the subwoofer. Step 3 Plug the brown connector from the left satellite into the brown jack on the subwoofer. Step 4 Plug the AC plug into the wall outlet. Step 5 Turn on the speaker set and adjust the volume accordingly. file:///D|/HK1500/setup. htm (2 of 7)11/16/2004 3:52:52 AM Setup: harman/kardon HK1500 Audio System file:///D|/HK1500/setup. htm (3 of 7)11/16/2004 3:52:52 AM Setup: harman/kardon HK1500 Audio System file:///D|/HK1500/setup. htm (4 of 7)11/16/2004 3:52:52 AM Setup: harman/kardon HK1500 Audio System file:///D|/HK1500/setup. htm (5 of 7)11/16/2004 3:52:52 AM Setup: harman/kardon HK1500 Audio System file:///D|/HK1500/setup. htm (6 of 7)11/16/2004 3:52:52 AM Setup: harman/kardon HK1500 Audio System Back to top Placement of speakers The speakers are magnetically shielded and can be placed close to a computer monitor without distorting the image. Disconnect all speaker cables from the sound card. To test the front speaker channel, plug the green connector into the diagnostic jack on the rear of the subwoofer. This tone will alternate from the Subwoofer to the satellites and back again. The diagnostic test can also be used to test the rear speaker channel input by plugging in the black connector into the diagnostic jack on the rear of the subwoofer. (Test tone may sound different due to the surround characteristics of speaker system). When you have finished the test, unplug the cable from the `DIAG' jack and plug the audio cable back into the correct soundcard output jack. While the speaker system is in the diagnostic mode, the -/+ controls will control the volume of the diagnostic tone. If the test tone was heard from all speakers, your HK1500 Audio System is working correctly. If not, see the troubleshooting section for detailed troubleshooting techniques. file:///D|/HK1500/usage. htm (4 of 5)11/16/2004 3:53:03 AM Using the speaker system: harman/kardon HK1500 Audio System Back to top Back to Contents Page file:///D|/HK1500/usage. htm (5 of 5)11/16/2004 3:53:03 AM Diagnostics: harman/kardon Hk695 Audio System Back to Contents Page Diagnostics: harman/kardon HK1500 Audio System In order to facilitate optimal system setup, a diagnostic system has been built in to the harman/ kardon HK1500 Audio System. If you are having trouble getting sound out of your system, or are not confident that your setup is optimal, use these system diagnostics to configure your harman/kardon HK1500 Audio system. Disconnect all speaker cables from the sound card. [. . . ] Input cables not plugged in properly. Subwoofer emits a loud hum or buzzing noise. file:///D|/HK1500/trouble. htm (2 of 3)11/16/2004 3:53:09 AM Troubleshooting: harman/kardon Champagne HK1500 Audio System Speaker System emits a loud hum or buzzing noise when used with a stereo only (not multichannel) soundcard. Speaker system experiences radio frequency interference or picks up a radio station. The redundant rear (black) audio connector is not protected by the rubber cover and is touching the computer system Input cable may be picking up interference. Replace the rubber cover or otherwise insulate the rear audio connector so it cannot contact any metallic surfaces Wrap up excess input cable in order to make as short as possible. Purchase a ferrite clamp and attach over input cable. A clamp can be purchased at your local electronics store. Getting Help If the troubleshooting procedures in this document do not resolve the problem, please contact DellTM Computer Corporation for technical assistance (refer to the "Getting Help" section in your system documentation). For information about your DellTM warranty, see your DellTM system documentation. Back to Contents Page file:///D|/HK1500/trouble. htm (3 of 3)11/16/2004 3:53:09 AM Specifications: harman/kardon HK1500 Audio System Back to Contents Page Specifications: harman/kardon HK1500 Audio System Dimensions · Power Manufacturer Model Number Drivers (satellite) Drivers (subwoofer) Power (satellite) Power (subwoofer) Crossover Frequency (subwoofer) Dimensions Width: Satellite Subwoofer Depth: Satellite Subwoofer Height: Satellite Subwoofer Input Impedance Signal-to-Noise ratio Harman International harman/kardon HK1500 Audio System Two Odyssey One 5. 25 inch woofer 6 Watts per satellite @ 1% THD +N 28 Watts @ 1% THD+N 180 Hz 3. 5 inches 11. 75 inches 5. 75 inches 11. 75 inches 11. 5 inches 13 inches 5k- 10k Ohm >70 dB file:///D|/HK1500/specs. htm (1 of 2)11/16/2004 3:53:15 AM Specifications: harman/kardon HK1500 Audio System Frequency Response Input Sensitivity 35 ­ 20 kHz 300-400 mV rms. [. . . ]