User manual HARMAN KARDON HK60

[. . . ] The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 1. All the safety and operating instructions should be read before the product is operated. The safety and operating instructions should be retained for future reference. All warnings on the product and in the operating instructions should be adhered to. [. . . ] Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. The power-supply cord or the plug has been damaged; or b. Objects have fallen onto, or liquid has been spilled into, the product; or c. The product has been exposed to rain or water; or d. The product does not operate normally when following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation; or e. The product has been dropped or damaged in any way; or f. The product exhibits a distinct change in performance; this indicates a need for service. When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part. If that is not possible, they may be placed on a wall behind the listening position, facing forward. The surround speakers should not call attention to themselves. Experiment with their placement until you hear a diffuse, ambient sound accompanying the main-program material heard in the front speakers. The low-frequency material reproduced by the subwoofer is mostly omnidirectional, and this speaker may be placed in a convenient location in the room. However, the best reproduction of bass will be heard when the subwoofer is placed in a corner along the same wall as the front speakers. Experiment with subwoofer placement by temporarily placing the subwoofer in the listening position and moving around the room until the bass reproduction is best. Place the subwoofer in that location. Stands are optional. The center-channel speaker should be placed slightly behind the front left and right speakers, and no more than two feet above or below the tweeters of the left and right speakers. It is often convenient to set the center speaker on top of the television set, as shown in the drawing. Use the supplied support leg to aim it toward the listener by screwing the leg in to angle the speaker up, or unscrewing the leg slightly to angle the speaker down. 5 MOUNTING OPTIONS Satellites and Surrounds Wall Mounting On shelves. The brackets should be placed, if possible, so that the screws will fasten into a wooden wall stud. If that is not possible, use properly selected wall anchors. [. . . ] When the "Auto/On" switch TM is switched to the "On" position, the subwoofer will remain on, whether or not program material is playing. If you will be away from home for an extended period of time, or if the subwoofer will not be used, switch the Master Power switch ¡ to the "Off" position. £ SUBWOOFER LEVEL TM ¡ AC 120V~60Hz 200W POWER MIN RED: STAND BY -- MAX O -- GREEN: ON FUSE 2. 5A/250V TYPE T ON n AUTO n L R LINE LEVEL INPUT SUB SUB-TS 2 OUT + R HIGH ­ LEVEL IN This area is designed to be quite warm during normal operation. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ­ L + IMPORTANT: CONNECT STRIPED WIRE TO RED (+) SPEAKER TERMINAL. Volume Volume can be adjusted using the Subwoofer Level Control £, as shown below. Subwoofer Level Subwoofer Level MIN MAX MIN MAX 10 TROUBLESHOOTING If there is no sound from any of the speakers: · Check that receiver/amplifier is on and a source is playing. · Check that the powered subwoofer is plugged in and its Power switch ¡ is switched on to the "·" position. · Check all wires and connections between receiver/amplifier and speakers. [. . . ]