User manual HARMAN KARDON HK6300

[. . . ] While sophisticated systems are hard at work within the HK6300 to make all of this happen, hookup and operation are simple. Color-keyed connections and a comprehensive remote control make the HK6300 easy to use. To obtain maximum enjoyment from your new receiver, we urge you to take a few minutes to read through this manual. This will ensure that connections to speakers, source playback units and other external devices are made properly. [. . . ] ¬ Auto Preset: When the tuner and FM band have been selected, this button may be used to automatically program the tuner presets for all active stations. To start the auto preset scan, press and hold the button. Note that the MEMO and PRESET indicators will flash. After a few seconds, the tuner will start to "look" for active stations, as shown by increasing frequency numbers in the Information Display. Release the button and note that the tuner will briefly stop at each active station and add a preset number to the memory. If the FM tuner finds fewer than 30 FM stations with acceptable signal strength, the Auto Preset tuning will scan two more cycles or until the remaining vacant preset memory spaces have been filled with those found in the first scan. The scan will stop when all 30 preset memory spaces have been filled or when three scans through the band have been completed. µ Secondary Control Cover: This sliding cover normally is in the "up" position so that it hides the secondary controls. To access these controls, place your thumb on the small recessed area at the top center of the control, and gently press the cover down and towards you. Ñ Clear Button: This button is used to clear preset memory information for the HK6300's tuner. (See page 14 for more information on tuner presets. ) ø Memory Button: Press this button to open a memory position that stores a preset location for the HK6300's tuner. Connect the Play/Out jacks of a cassette deck, MD or other audio recorder to the Tape Monitor In jacks ª. Connect the Record/In jacks on the recorder to the Tape Monitor Out jacks , on the HK6300. When the tape deck connected to these jacks is a three-head unit or has off-head playback, it will be possible to monitor the output of the source being recorded. Connect the output of a second audio recorder, VCR or other line-level audio device to the Tape 2 Play/In jacks /. If a recorder is used, connect its Rec/In jacks to the matching outputs ¤. The output of any electronics product with a line-level output, such as a TV set, satellite receiver or DVD, may be connected to the Aux jacks ·. Connect the outputs of a turntable with a moving magnet cartridge to the Phono inputs §. To insure that the phono playback is noisefree, connect the ground wire from the tone arm to the Phono Ground terminal £. Assemble the AM Loop Antenna supplied with the unit as shown below. Connect it to the AM screw terminals ¡. When connecting wires to the speakers, be certain to observe proper polarity. [. . . ] When the preset station to be removed has been tuned, first press the Memory button O. The MEMO and PRESET indicators in the Information Display will flash, and the actual preset number will disappear from the display. Next, press the Clear button N within five seconds. The preset station will be removed from the memory, and the action will be confirmed by the brief appearance of the word CLEAR and the preset number location in the Information Display. [. . . ]