User manual HARMAN KARDON GO PLAY MICRO

[. . . ] Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. [. . . ] Music controls ­ Manage the music lists on your iPhone/iPod with the Play/Pause, Next Track, Previous Track, Menu, Scroll Up and Scroll Down controls. Harman Kardon Go + Play Micro unit Power supply Remote control 3 English General Setup Unpack the Harman Kardon Go + Play Micro System and Its Power Supply on the back of the unit and then into a wall outlet 1. Plug the adapter into the 24V DC IN port 2. Turn on the power button on the top of the unit. Remove the remote control battery protector before operating the remote control. Battery Installation 1. Unscrew the two battery compartment cover screws counterclockwise to the unlocked position; remove the battery compartment cover. Place eight (8) fresh C-cell batteries as shown. Note: System will not use battery power when using AC power. 1. 1. 2. 2. 3. DO NOT MIX BATTERY TYPES. DO NOT MIX CHARGED AND PARTIALLY CHARGED BATTERIES. BATTERIES WILL NOT RECHARGE WHILE IN THE UNIT Battery Disposal Volume Control (On-base Unit) Volume increase Volume decrease Alkaline batteries are considered nonhazardous. Rechargeable batteries (i. e. , nickel cadmium, nickel metalhydride, lithium and lithium-ion) are considered hazardous household materials and may pose an unnecessary health and safety risk. In the European Union and other locations, it is illegal to dispose of any battery with household trash. All batteries must be disposed of in an environmentally sound manner. Contact your local waste management officials for information regarding the environmentally sound collection, recycling and disposal of used batteries. 4 Listening to Music from an iPhone/iPod 1. Press the power button on the top of the Harman Kardon Go + Play Micro system to turn the unit on. Select and play music using the controls on the iPhone/iPod or send commands to the iPhone/iPod with the remote control. Adjust the volume using the "+" and "­" buttons located on the top of the Harman Kardon Go + Play Micro loudspeaker. Remote Functionality Listening to Music from an Auxiliary Device The Harman Kardon Go + Play Micro system includes a 3. 5mm mini jack cable for connection to any analog music player with either a 3. 5mm or headphone output. Connect the auxiliary device to the Harman Kardon Go + Play Micro system audio input port using a audio cable (not included). Press the Power button on the top of the Harman Kardon Go + Play Micro system. A white light will indicate that the unit is on. Control music playback through the auxiliary device. Adjust the volume using the "+" and "­" buttons located on the top of the Harman Kardon Go + Play Micro loudspeaker. Enter Previous Track Play/Pause Scroll Down Mute Menu Next Track Scroll Up Volume Decrease Volume Increase USB Synchronization and Charging The Harman Kardon Go + Play Micro system features a USB synchronization and charge port. This feature allows synchronization of the Go + Play Micro system, with an iPhone/iPod docked, to iTunes and provides a charge to the iPhone/iPod even when the Harman Kardon Go + Play Micro is only under battery power. [. . . ] Some devices will distort the output signal if the volume is set to maximum. It is recommended that the source device EQ be set to "Flat" or "Off. " Incorrect source selection. Volume level may be too high. Harman Kardon Go + Play Micro unit emits a loud hum or buzzing noise. Harman Kardon Go + Play and Atlas are trademarks of Harman International Industries, Incorporated. [. . . ]