User manual HARMAN KARDON HKTS 30

[. . . ] HKTS 20/HKTS 30 Home Theater Speaker System User Guide English Designed to Entertain. TM Important Safety Instructions Please read the following precautions before use: 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Place the subwoofer in that location. 3. Disassemble the wall-mount bracket by sliding the two sections apart, as shown in the illustration. Attach the wall portion of the wall-mount onto the wall using hardware that is appropriate for the wall's construction and materials. We recommend first anchoring the mount using its keyhole, then attaching it with another anchor through its top opening, as shown in the illustration. Note that the satellite speakers weigh 3. 3 lb (1. 5kg). Be sure to use hardware that can support this weight. Top Opening Keyhole Opening Bottom Opening Placing the Surround Speakers Left Front Speaker Left Surround Sound Right Surround Sound 5 - 6 ft (1. 5m - 1. 8m) Center Speaker Right Front Speaker Subwoofer Left Surround Sound Right Surround Sound 5 ENGLISH Speaker Placement NOTE: If you're running the speaker wire through the wall you can bring it out directly behind the bracket location and insert it through the bottom opening in the wall portion of the wall-mount, as shown in the illustration. This will keep the wire completely hidden from view once the installation is complete. 8. Connect the speaker wire to the speaker terminals as shown in the illustration: a) Press down on the top of the terminal to open the connection hole. b) Insert the wire's bare end all the way into the hole. c) Release the terminal to secure the wire. Insert the conductor with the colored band into the speaker's red ( + ) terminal, and insert the other conductor into the speaker's black ( ­ ) terminal. Insert Wire into Bottom Opening Bring Wire Out through Here + ­ 5. If you're not running the speaker wire through the wall, insert it through the wall portion of the wall-mount bracket as shown in the illustration. A. Release Cap to Secure Wire IMPORTANT: Make sure the ( + ) and ( ­ ) bare wires do not touch each other or the other terminal. Touching wires can cause a short circuit that can damage your receiver or amplifier. Slide the speaker portion of wall-mount onto the speaker as shown in the illustration. Fit the grooves on the mount onto the rails in the speaker, and apply even pressure on both sides of the mount so it slides straight onto the speaker. · Push the mount all the way onto the speaker until it snaps into place. · Pull any slack speaker wire back through the mount as you slide the mount onto the speaker. Push Down Evenly on Both Sides of Bracket 6. Pass the speaker wire through the speaker portion of the wall-mount as shown in the illustration. Fit Bracket Grooves onto Speaker Rails Bring Wire In through Here Bring Wire Out through Here 10. Slide the speaker onto the mount's wall section as shown in the illustration. Pull any slack speaker wire back through the mount's wall section. 7. If you have not already removed the speaker's base, do so by pulling it straight off the speaker, as shown in the illustration. [. . . ] If it is not, check to see if your receiver/amplifier has a different surround-sound mode that you can use. Review the operation of your DVD player and the DVD jacket to make sure the DVD features the desired Dolby Digital or DTS® surround-sound mode, and that you have properly selected that mode using both the DVD player's menu and the disc's menu. Check that the subwoofer's Power Cord 8 is plugged into a working AC outlet. Check that the subwoofer's Power Switch 7is in the ON position. [. . . ]