User manual HARMAN KARDON MS 100

[. . . ] banner head MS 100 MUSIC SYSTEM OWNER'S MANUAL 1 SaFeTY InFOrMaTIOn Important Safety InStructIonS 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Use the / Buttons to move the cursor to the previous or next setting. To arm the alarm, use the / Buttons to change the Alarm message to "Alarm On", and press the Alarm Adjust Mode Button again when you are finished. The Timer indicator will appear in the Message Display when the alarm has been set. At the set time, the MS 100 will automatically turn on and begin playing the selected source. If CD or iPod was selected and there is no disc loaded or iPod docked, the MS 100 will switch to the FM radio source. Play will begin at volume level 8, and steadily increase to a volume level of 20 within 3 minutes. It will continue to play at level 20 for 45 minutes, and then shut off automatically. Press any key to place the unit in Snooze mode. It will remain off for 9 minutes, then the alarm will resume. Press and hold the Standby Button while the alarm is playing to turn it off and return to normal play. using the remote control Point the remote at the front of the MS 100. The remote IR sensor is located in the middle of the front panel, behind the mesh grille, about 25mm above the CD slot. The remote has a range of approximately 6m, up to 30 degrees off center. If the batteries require replacement, see Step 2 of the Installation section. Use caution and dispose of batteries according to environmental requirements. Never throw the batteries into fire, and remove them from the remote if it will be unused for a long period of time. Volume control Use the front-panel or remote Volume Controls to raise or lower the volume. The default setting at turn-on is 8, and the maximum setting is 30. Use caution with volume levels to avoid damage to your hearing or equipment. The volume level appears in the Message Display when the Volume Controls are used. To temporarily silence playback, press the Mute Button on the remote, or simultaneously press the front-panel Volume Up and Down Buttons. "Mute" will flash in the Message Display. Press the Mute Button or either Volume Control to resume normal volume. Source playback will continue during muting. 30º STANDBY ON 30º SOURCE TUNE PLAYBACK SLEEP CLOCK ADJ ALARM ADJ PR­ EJECT PR+ TUNE­ TUNE+ MUTE Setting the clock VOLUME Before turning the unit on, set the clock: Press the Clock Adjust Mode Button on the remote, and use the / buttons to set the correct hour and minute settings when they flash. [. . . ] SoLutIon · akesuretheACpowercordissecurelypluggedintoanunswitched M outlet. If the "PROTECT" message appears, turn off the MS 100 and unplug it. Do not use it without first bringing it to an authorized Harman Kardon service center for inspection. · resstheMuteButtontomakesurethesystemisnotmuted. [. . . ]