User manual HARMAN KARDON VCD1000

[. . . ] A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Press this button again at any time when finished. preset Search: Used for FM radio to select the next or previous preset station, if any have been programmed. eject: When a CD is loaded, press this button to eject it. Press and release to tune to the next higher or lower station by one frequency increment. Press and hold to scan quickly through the stations. · pair of rca-type analog audio outputs: Plug one end of a two-conductor interconnect cable (not included) into the player, and the other end into the Auxiliary Input jacks on the rear-panel of the VCD1000. Use the same color connector for each channel (usually red for right and white or black for left). · optical-digital audio S/p-DIf output: Plug one end of the included digital audio cable into the player, and the other end into the Analog/Optical Input on the rear panel of the VCD1000. Remember to select the digital input as the source. 3. Plug the detachable dock for iPod into the connector on the left side of the VCD1000. 6. If you have purchased an optional powered subwoofer that is equipped with a line-level input, connect it to the Subwoofer Output (cable not included). To temporarily silence playback, press the Mute Button on the remote, or simultaneously press the front-panel Volume Up and Down Buttons. "Mute" will flash in the Message Display. Press the Mute Button or either Volume Control to resume normal volume. Source playback will continue during muting. 30º STANDBY ON 30º SOURCE TUNE PLAYBACK SLEEP CLOCK ADJ ALARM ADJ PR­ EJECT PR+ TUNE­ TUNE+ MUTE Setting the clock VOLUME Before turning the unit on, set the clock: Press the Clock Adjust Mode Button on the remote, and use the / buttons to set the correct hour and minute settings when they flash. To change between AM and PM, increase or decrease the hour setting. Use the / Buttons to move the cursor to the previous or next position, and press the Clock Adjust Mode Button again when you are finished. See Figure 1. Source Selection The first time the VCD1000 is turned on, it will default to FM Radio. Each press of the Source Selector switches to the next source in this order: FM, CD, AUX LINE IN 1 (rear-panel 3. 5mm analog input), AUX LINE IN 2 (front panel), AUX LINE IN 3 (rearpanel dual RCA jacks), AUX DIGITAL IN, iPod. Subsequently, the VCD1000 will select the last source used before turn-off. turning on the mS 100 To turn on the VCD1000, press the Power On Button on the remote, or press the On/Standby Button on the main unit. The FM Radio will begin to play. fm radio Press the Tuning Mode Button to select Automatic or Manual tuning. The AUTO indicator appears when Auto tuning is active. [. . . ] After a few moments, a slideshow of the images in the selected library will appear on the TV. undocking the ipod Undock the iPod at any time, as long as playback has been stopped. To remove the dock adapter, e. g. , to switch adapters for a different iPod model, insert a flathead screwdriver into the slot at the rear of the adapter and pry it up. Refer to the illustration in the Installation section. 12 TrOUbLeShOOTInG English trouBLeSHootInG GuIDe Symptom Unit does not function when Power On Switch is pushed. [. . . ]