User manual HASBRO 101 DALMATIONS PUPPY RESCUE CARD GAME

[. . . ] Insert 4 x 1. 5V "AA" or LR6 alkaline batteries. Replace door and tighten screw. IMPORTANT: BATTERY INFORMATION CAUTION: 1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching the + and ­ polarity markings. [. . . ] Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries. ** 3. Remove exhausted or dead batteries from the product. Remove batteries if product is not to be played with for a long time. Do not short-circuit the supply terminals. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from the product before recharging. Recharge batteries under adult supervision. Do not force them. Robot stops suddenly. Weak battery. The robot is out of range of the controller. The robot is di cult to control. You may be experiencing interference from another device. Bright lights are a ecting the infrared (IR) control. Feet are not aligned. Remote batteries may be exhausted. Robot batteries may be exhausted. Missile launchers become detached. 1-888-722-3972. For further assistance call: FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that maycause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. [. . . ]