User manual HASBRO ACTIONMAN SILVER SPEEDER

[. . . ] Turn unit right-side up once screws are inserted. bottom rod top rod door as shown. Attach the right fence panel to the other side of the threshold as shown. NOTE: You will hear a "snap" when these pieces are properly connected. STEP 1: Slide the threshold into the left fence panel/ STEP 4: Lie the fabric dome out flat as shown. [. . . ] Lift STEP 2: Place the left front support under the left fence panel/door. Gently press fit left fence panel/ door down onto left front support as shown. Repeat step for right front support and right fence panel. the top of the fabric dome up and connect all 4 built-in support rods by inserting the top rod into the bottom rod as shown. NOTE: Rods are made to flex for increased ease of assembly. You may need to slide the fabric up on the rods to assemble posts. tab slot STEP 5a: Insert the fabric dome's 2 front rods into the 2 rod holders located on the left and right front supports. NOTE: Left front rod is marked: LF Right front rod is marked: RF STEP 8: Insert the tab on the front of the fabric dome into the slot on the back of the fence panels as shown. STEP 5b: Turn the unit on its side and secure the 2 front rods to the 2 rod holders by inserting washer head screws in each screw point. STEP 9: Attach tube bottom to slot on left front support. Secure tube to fabric with tabs as shown. STEP 6a: Connect the right rear base to the left rear base. STEP 6b: Turn the newly connected rear base over and secure it by inserting washer head screws in the screw points . STEP 10: Attach the shape sorter lid to the shape sorter mailbox as shown. PLAY FEATURES: Place the playmat on the floor. NOTE: Place the dome on the playmat so that the dome covers the corners of the playmat. Your child will love to explore the activities on the playmat, which include: · Peek-a-boo crinkly leaf · Fun-to-touch satin flower STEP 7a: Insert the fabric dome's 2 back rods into the 2 rod holders located on the rear base. NOTE: Left back rod is marked: LR Right back rod is marked: RR · Pull ribbon "hair" on the monkey STEP 7b: Lift the rear panel and secure the 2 back rods to the 2 rod holders by inserting washer head screws in each screw point. Please see your LET'S PLAY TOGETHER tip card (included) for all kinds of great play activities and ideas! DECORATIONS, STORAGE AND PORTABILITY: 1. Hanging toys can be attached to loops on the sides or at the top as shown. Do not short circuit the supply terminals. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES. FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ]