User manual HASBRO BATMAN AND ROBIN BAT TAZER

[. . . ] · Exhausted batteries are to be removed from the toy. · The supply terminals are not to be short-circuited. · Do not mix old and new batteries. · Do not mix alkaline, standard or rechargeable batteries. [. . . ] We recommend this button for expert drivers only-- but feel free to experiment and try it out! V. IMPACT SENSORS You may have noticed by now the red lights on top of your BattleBot. · When all the lights are fully lit, your Bot is operating at 100% efficiency. · If a light is flashing, your Bot has taken "virtual damage. " If the Bot takes another hit, the flashing light will turn off. As you lose those lights, your Bot is in danger of a catastrophic shutdown!· If all the lights go out, your Bot has been disabled. Your controller will not work until you reset your Bot. You can do this by using the on/off switch, or by simply pressing the RESET button on top of your Bot. Once your Bot is reset, you can continue playing. The impact sensor is specially designed to register flips and hits from the sides, but NOT hits from the front or rear. It means if you can ram the front of your Bot into the side of your opponent, he will take a hit but YOU will not! STRATEGY. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio TV technician for help. This is a good hit! Be careful, though!There is always a chance your Bot will take damage from any collision. [. . . ] (You may wish to use the RESET button to prepare each Bot for battle. ) · Turn on your controllers but do not start fighting-- yet!· The Judge will officially start the match (and the clock) and both players can begin battling. · The match lasts for 3 minutes or until one Bot is disabled-- whichever comes first. · The first Bot to be disabled loses the match. [. . . ]