User manual HASBRO BATMAN AND ROBIN REMOTE CONTROL BATMOBILE

[. . . ] Not suitable for children under 36 months, may contain small parts. To ensure proper function : · Battery installation should be done by an adult. · Non-rechargeable batteries are not to be recharged. · Rechargeable batteries are to be removed from the toy before being charged (if removable). [. . . ] Add the Bot's protective body shell by simply pressing it straight down onto the chassis as shown. You will notice that your offenses are geared directly into your drive system. You don't have to do anything special to operate your offenses-- just line your Bot up with the victim, and drive right for him! NOTE: Your BattleBot has a failsafe system. It will not operate unless the attachment is FULLY inserted. You will notice that your BattleBot controller also features a TURBO button and a SPIN button. We recommend these buttons for expert drivers only-- but feel free to experiment and try it out! V. IMPACT SENSORS You may have noticed by now the red light on top of your BattleBot. · When the light is fully lit, your Bot is operating at 100% efficiency. · If the light is flashing, your Bot has taken "virtual damage" and is in danger of a catastrophic shut-down!· If the light goes out, your Bot has been disabled. Your controller will not work until you reset your Bot using the on/off switch. Turn the Bot off and back on again and you can continue playing. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio TV technician for help. Be careful, though!There is always a chance your Bot will take damage from any collision. [. . . ] · The match lasts for 3 minutes or until one Bot is disabled-- whichever comes first. · The first Bot to be disabled loses the match. If 3 minutes pass and both Bots are still moving, the Judge must award points and make a decision. · Points are awarded as follows: AGGRESSION. [. . . ]