User manual HASBRO CANDY LAND 50TH ANNIVERSARY EDITION SPANISH

[. . . ] Insert dump bucket handle through elevator right side. d) Snap elevator into elevator base and elevator support. Dump Station Assembly: d elevator support 2. dump station sign d label elevator left side elevator right side d b elevator support base dump station supports a) Fit left dump station support into left dump station support base. b) Fit right dump station support into right dump station support base. c c elevator base a c c) Fit dump station on top of left and right supports. Snap sign into grooves as shown at top of diagram. b a dump bucket dump station support base Boulder Chute Assembly: 3. c label label b label boulder chute center gate Garage Assembly: 4. a a a back roof lamp c roof ridge sign front b label a) Attach boulder chute to assembled elevator and dump station units as shown. [. . . ] Snap sign into grooves. garage curbs garage floor a) Fit garage front and back pieces together. b) Fit assembled front and back pieces onto garage floor. c) Attach roof ridge, roof lamp, garage curbs and label as shown. BASIC MOTORIZED TALKING PLAY INSTRUCTIONS: BASIC MOTORIZED TALKING PLAY INSTRUCTIONS: truck start button "Time to go to work Chuck!" garage start button on light 1. Push start button located on CHUCK THE DUMP TRUCK'S cap. (Light on hood indicates that truck is ON. ) 2. Place truck inside garage (front of truck should be pushed against switch on rear wall), then close garage door. Press start button located on top of garage. 4. Animated mouth (door) and eye brows on garage move as GARY GARAGE "speaks. " 5. Garage door opens and truck backs out, then drives in a circle in front of garage. Truck returns to garage when GARY GARAGE says a "come home" phrase. MOTORIZED TALKING PLAY FEATURES: · Motorized truck automatically returns to garage only when it is inside the interactive zone. Use only batteries specified and be sure to insert them correctly by matching the + and ­ polarity markings. 2) Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline batteries. 3) Remove exhausted or dead batteries from the product. 4) Remove batteries if product is not to be played with for a long time. 5) Do not short-circuit the supply terminals. 6) Should this product cause, or be affected by, local electrical interference, move it away from the other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary. 7) RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from the product before recharging. Recharge batteries under adult supervision. [. . . ] Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ]