User manual HASBRO CONTACT

[. . . ] XXXX represents your media size choice (for envelopes, select The setting is engaged and the second line of the display stops blinking. If you are setting the MP Tray for heavy paper or labels, keep going. The second line of the display starts blinking. The setting is engaged and the second line of the display stops blinking. [. . . ] The ink on pre-printed letterhead stationery must be able to withstand 446°F (230°C) for 0. If you experience curling when printing a file in duplex mode, switch to 28-lb. Weight designations in this column are US Bond. Transparencies must be able to withstand 446°F (230°C) for 0. Make the following settings in the printer driver as you print the job: · Labels must be able to withstand 446°F (230°C) for 0. Make the following settings in the printer driver as you print the job: · Make the following settings in the printer driver as you print the job: · To avoid damage to the printer, always change the printer settings when printing on thick media. Size = see sizes at left · Envelopes must be able to withstand 446°F (230°C) for 0. Never use envelopes with metal clasps, snaps, windows, or V-flap seals: Make the following settings in the printer driver as you print the job: · To purchase Oki media, contact your local Oki dealer or visit us at Indicates that you should keep pressing the button repeatedly until you see the display indicated. Power Save sets how long the printer waits before going into standby mode. This saves energy, but the printer requires time to warm up when it receives a print job or if you want to enter the menu and change settings. Indicates that you should keep pressing the button repeatedly until you see the display indicated. 4 Make sure the lever is pulled all the way forward before attempting to remove the toner cartridge!The TONER LOW message should disappear from the display. If it doesn't, try printing a page. Some of the more common error messages appear below. Appears on the second line of the display to indicate that the lever for the toner cartridge color indicated is not pushed all the way back. Push the lock lever toward the back of the printer as far as it will go. If this does not clear the message, call your local service dealer. (See the instructions supplied with the new image drum. Appears on the second line of the display to indicate that color XXX toner cartridge is getting low. Note:If you have changed the LOW TONER item in the SYSTEM CONFIG MENU to STOP, the ATTENTION light will blink and you must either replace the toner cartridge immediately or press the ON LINE button to continue printing. Reduce the size of the file being printed (e. [. . . ] Load the requested media (XXX) in the Multi-Purpose Tray, then press ON LINE. Appears on the second line of the display to indicate that the media in tray t is almost out. , 450: TRAY 1) is not a size that can be fed through the tray. Load more media in the tray before printing any large print jobs from that tray. [. . . ]