User manual HASBRO DELUXE TOOLS SET SOCKET SET

[. . . ] Prior to and during assembly of this product, keep small parts out of children's reach. Small parts pose a choking hazard to children under 3 years. CAUTION: WARNING: TO AVOID SERIOUS INJURY: Continuous adult supervision required; never use motor vehicles, near streets, swimming pools, hills, steps or sloped driveways. [. . . ] 06717 P/N 6293990300 WARNING: PLAYSKOOL. COM Questions?Call: 1-800-PLAYSKL FOR NEW PRODUCTS AND OFFERS Always wear protective equipment including helmet, wrist guards, knee pads and elbow pads (not included). Close-toed shoes or sneakers must be worn. ASSEMBLY 1. Attach End piece to Base Fit end piece onto base. From underside of base, tighten 2 screws into base and end piece. END PIECE 2. Attach Top Handle to Vehicle Body Fit top handle onto vehicle body (align 3 tabs on holder with slots on body). You will hear a "click" once each wheel is properly connected. Once the wheels are snapped into place, test each wheel by hand to make sure that it rotates freely. NOTE: If you have followed these steps and the wheels do not rotate freely repeat steps 2 and 3 and apply more pressure to the wheels. If wheels still do not spin freely after proper assembly, call 1-800-PLAYSKL. 1. ROUNDED SIDE FACING OUT LARGER WHEEL ATTACH TO AXLE For growing toddlers, the RIDE2ROLL Scooter is a foot-to-floor ride-on that offers extra height and leg room. If the toy is in scooter mode: · Push latch on vehicle body downward and bring vehicle body down until it locks into place. Be sure the word "LOCKED" appears on latch. [. . . ] Be sure the word "LOCKED" appears on latch. Push downward to convert to LO RIDE-ON CK ED SMALLER WHEEL ATTACH TO REAR Now you're ready to ride! RIDE-ON MODE RIDE-ON 2. SCOOTER As your child grows steadier on his feet, this toy easily converts to a child's first scooter that encourages balance, coordination and timing. [. . . ]