User manual HASBRO DRIVE YA NUTS

[. . . ] Remove Batteries if product is not to be played with for a long time. Do net short-circuit the cross terminals. . Should thls product causa, or be affected by, local electrical interference, move i t away from other eleotried equipment. Reset (switching off and back on again or removing and re-inserting batteries) If necessary. [. . . ] Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES. As with all small items, these batterles should be kept away from children. If swallowed, seek medical attention immediately. N-S7'RIKE DISK SHOTMBLAS7ER Wireless Remote Motton Button Launch Button Pull B a d Mechanlsm 6 Mlcm Dartsm ~rlgger SETnNG UP 7HE GAME 1. Conned the Power Adaptor to the Disk Launcher 2. Attach the Loading Arm to the back of the first, then plug it into an electric outlet. Pull back the Loading Arm and insert the Disks, with the black side of Disks facing you. The Disk Launcher can hold a minimum of one Disk or a maximum of 12 disks. Place the Disk Launcher on a level floor. A Safety Switch on the bottom of the unit will register whether or not the launcher is resting on a level floor. If your friend has his or her own N-STRIKEQblaster (sold separately), one player could launch the Disks with a Wireless Remote and both players could try to hit them at the same time. rips This product is for indoor use only. Do not take the Disk Launcher outdoors or expose it to natural elements such as wind, rain, or snow. Do not use the Disk Launcher or play this game with anything other than N-STRIKEQblasters. I'm pressing the Wireless Remote buttons and nothing is happening with the Disk Launcher. The three (3) LED lights on the unit are flashing. A tone is repeating and will not stop. - Make sure, when you are pressing the buttons on the Wireless Remote, that you are aiming the Wireless Remote at the Disk Launcher. The unit may be in Sleep Mode: turn it off and back on. Make sure ou have fresh batteries in the Wireless Remote and that the r Disk ~ a u n d eis plugged into a working electrical outlet. Unplug the Disk Launcher and attempt to dislodge the stuck Disk. There are no Disks in the unit, or the Loading Arm is not attached. Check to make sure there are no Disks stuck in the unit. Turn the unit back on again. FCC STATEMENT This device complies with part 15 of the FCC Rules. [. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifmtions to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]