User manual HASBRO DUSTY THE TALKING VACUUM CLEANER COOL CREW 08764

[. . . ] 2 interactive personalities talk to each other!Vacuum cleaner pivots up and down. . . just like a real one! Tethered brush clips onto vacuum cleaner for storage! "Is that a rabbit?" "Na! [. . . ] It's just a dust bunny. " Note: When storing toy, turn the switch to "OFF" to prevent accidental activation. If toy does not respond, reset by moving the switch to off, then on To Replace Batteries Using a Phillips/cross head screwdriver, loosen screw in battery cover (screw will remain attached to cover). Insert 3 fresh 1. 5V "AA" or R6-size batteries into battery compartment. Replace cover and retighten screw. CAUTION: TO AVOID BATTERY LEAKAGE 1) Be sure to insert the batteries correctly and always follow the toy and battery manufacturers' instructions; 2) Do not mix old and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries; 3) Always remove weak or dead batteries from the product. IMPORTANT: BATTERY INFORMATION Please retain this information for future reference. Batteries should be replaced by an adult. CAUTION: 1. Always follow the instructions carefully. DO NOT RECHARGE OTHER TYPES OF BATTERIES. FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and the receiver. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and the receiver. [. . . ]