User manual HASBRO GOOSEBUMPS A NIGHT IN TERROR TOWER

[. . . ] Keep batteries or things that could be swallowed away from young children. contact a doctor immediately if an object is swallowed. Immediately remove the batteries and discontinue use if. € the product is dropped or subjected to an impact in which the interior is exposed. [. . . ] GB 56 • When the shutter button is pressed halfway down, the distance at which the proper exposure is obtained appears on the LCD panel. Set the aperture to match the displayed distance to the shooting distance. Proper exposure is obtained at less than 1. 0 m, the lower area of the image on the LCD monitor of the camera may become dark. Change the flash range to adjust the aperture and ISO sensitivity. Proper exposure is obtained at more than 28 m. € In manual flash photography, if the power level is set at 1/1 then the flash will go off at full power. € The flash range check indication of the TEST button (blinks in green) does not work after a photo is taken with the manual flash. € The flash range is not shown when using upward flash bounce, with wireless flash, when communication with the camera is off, or when an off-camera cable is used. 57 GB Advanced Operations High-speed sync (HSS) High-speed sync Normal flash High-speed sync eliminates the restrictions of flash sync speed and enables the flash to be used through the entire shutter speed range of the camera. The increased selectable aperture range allows flash photography with a wide aperture, leaving the background out of focus and accentuating the front subject. € You can change the size of the power level setting steps so that with multiple flash up to 16 levels of light can be set. For more details on the size of power level setting steps, see page 94. GB 60 7 8 When setting is finished, press the middle of the control wheel to return to the normal indicator screen. € The shutter speed is calculated as follows to suit the selected flash frequency and number of flashes. number of flashes (TIME) ÷ Flash frequency (Hz) = Shutter speed For example, when ten flashes and 5 Hz are selected, 10 ÷ 5 = 2 requires a shutter speed of longer than two seconds. 9 When the flash is fully charged, press the shutter button to take the photo. € The distance at which the proper exposure is obtained with a single flash is displayed on the LCD panel. (The distance is not shown when using upward flash bounce, when communication with the camera is off, or when an off-camera cable is used) • To prevent shaking, the use of a tripod is recommended during multiple flash photography. € Test flash will flash at the selected frequency/number/level while the TEST button is being pressed if [1 TIME] is selected in the MENU settings. When [3 TIMES] or [4 SEC] is selected, the flash three times or the four second modeling flash has priority. 61 GB Advanced Operations Maximum number of continuous flashes The maximum number of continuous flashes during multiple flash photography is limited by the charge in the battery. [. . . ] € Store the flash unit in its case immediately after use. Before putting it in the case, make sure it is switched off and has sufficiently cooled down. 99 GB Maintenance Remove this flash unit from the camera. If the flash has been in contact with sand, wiping will damage the surface, and it should therefore be cleaned gently using a blower. [. . . ]