User manual HASBRO GYRUSS ATARI 5200

[. . . ] Do not place the naked flame sources such as lighted candles on the apparatus. To reduce the risk of fire or electric shock, do not expose this apparatus to dripping or splashing, and do not place objects filled with liquids, such as vases, on the apparatus. As the main plug is used to disconnect the unit from the mains, connect the unit to an easily accessible AC outlet. Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. [. . . ] € AC power cord (mains lead) must be changed only at the qualified service shop. € Do not place anything at the rear of the Sound Bar that might block the ventilation holes and cause malfunctions. € If the system is being used in combination with a TV, VCR, or tape deck, noise may result, and picture quality may suffer. In this case, place the system away from the TV, VCR, or tape deck. € Use caution when placing the system on surfaces that have been specially treated (with wax, oil, polish, etc. ) as staining or discoloration of the surface may result. € Take care to avoid any possible injury on the corners of the Sound Bar or the subwoofer. On operation Before connecting other equipment, be sure to turn off and unplug the system. If you encounter color irregularity on a nearby TV screen Color irregularities may be observed on certain types of TV sets. Turn off the TV set, then turn it on again after 15 to 30 minutes. On heat buildup Although the system heats up during operation, this is not a malfunction. Insert the plug of the AC power cord (mains lead) fully to the end. Subwoofer To the wall outlet DVD player, etc. digital coaxial cord (not supplied) Digital coaxial audio output DVD player , etc. TV Analog audio output Digital optical cord (supplied) Optical digital audio output Analog audio cord (not supplied) 10US Positioning the system The illustrations below are examples of how to install the Sound Bar. Note • When you select a place for the Sound Bar, do not block the heat ventilation on the rear panel of the Sound Bar. Installing the Sound Bar • Installing the Sound Bar on a rack • Installing the Sound Bar on a wall (page 12) Getting Started Note on installing the subwoofer Place the subwoofer so that the rear panel is at least ten centimeters (four inches) away from the wall. 10 cm (4 in) continued 11US Removing the stands When the Sound Bar is to be placed facing upward slightly or on a wall, remove the two stands at the bottom of the Sound Bar, as shown below. Insufficient wall strength, improper screw installation or natural calamity, etc. 1 Prepare screws (not supplied) that are suitable for the holes on the back of the Sound Bar. 4 mm (3/16 inches) Stand more than 25 mm (1 inch) 5 mm (7/32 inches) 10 mm (13/32 inches) Hole on the back of the Sound Bar Note • When the Sound Bar is placed facing upward slightly with the stands removed, take care not to block the ventilation holes with carpet, etc. The screws should protrude 7 to 8 mm (approx. [. . . ] When bass or treble is set to either minimum or maximum, the input indicators on the Sound Bar flash. press one of INPUT to select the input source. Input source Playable equipment OPTICAL COAXIAL ANALOG Device connected to the OPTICAL jack Device connected to the COAXIAL jack Device connected to the ANALOG jacks Enjoying sound at low volume (night mode) You can enjoy sound effects and hear the dialog clearly even at a low volume level (night mode). Night mode is available only for Dolby encoded TV programs, DVD, and Blu-ray discsTM. [. . . ]