User manual HASBRO H.I.S.S. III HIGH SPEED SENTRY

[. . . ] • Do not allow it to come in contact with large amounts of water. • If water should get on it or if it should fall into water, take it out immediately and wipe it off with a dry cloth. The interior of the battery compartment has no water-resistance. The battery may corrode, so wipe out the interior of the battery compartment as follows. [. . . ] • Stopwatch, split and pitch timer functions. • Wearable round design for armband and belt-holder use. • Water-resistant for all –weather use. • MEGA BASS for dynamic bass sound. Precautions • Operate the unit only on 1. 5 V DC with one size AAA (R03) battery. • Avoid exposure to temperature extremes, direct sunlight, moisture, sand, dust or mechanical shock. Never leave the unit in a car parked under the sun. • Should anything fall into the unit, remove the battery and have the unit checked by qualified personnel before operating it any further. • To clean the casing, use a soft cloth dampened with a mild detergent solution. • In vehicles or buildings, radio reception may be difficult or noisy. Try listening near a window. Output i (headphones) jack (ø 3. 5 mm stereo mini jack) 16 Ω Power output 5 mW + 5 mW (at 10 % harmonic distortion) Power requirements 1. 5 V DC, one size AAA (R03) battery Dimensions Approx. 95. 5 × 69. 3 × 37. 5 mm (w/h/d) (3 7/8 × 2 3/4 × 1 1/2 inches) incl. The unit can also be removed with the arm band attached on your arm, as instructed above. Countdown timer Pitch timer BAND DISPLAY To preset another station, repeat these steps. To change the preset station, preset a new station. To cancel the presetting mode, press MODE. Note If you do not press TUNE/TIME SET + or –, or ENTER within 65 seconds, the preset tuning mode will be canceled. 3 Press TUNE/TIME SET + or – to set the desired countdown duration for the pitch timer. The countdown duration can be set from 1 second to 59 minutes 59 seconds, in 1-second increments. 4 Press ENTER. The beep sounds and the number of times flashes in the display. Belt clip To vary the length of the rubber belt to fit your arm (See Fig. B– Move the velcro fastener to the proper position. If the rubber belt and wraparound band becomes dirty Remove the rubber belt from the unit and clean them. ) Playing the Radio — Manual Tuning 1 Connect the headphones to the i (headphones) jack. 2 Press POWER to turn on the radio. “RADIO ON” appears in the display. WB/FM SENS DX/LOCAL *2There is a tactile dot beside VOL to show the direction to turn up the volume. Caution (See Fig. B– ) • Avoid bending the wraparound band forcibly in the opposite direction. • The straightened band will wind easily when you touch or wiggle it. Be sure to treat it carefully. Tuning in to a Preset Station 1 Press POWER to turn on the radio. 2 Press MODE so that “P” and preset number appear. [. . . ] To turn off the radio before the preset time, press POWER. To pause the countdown on the countdown timer, press START/STOP while counting down. At this time, the countdown is reset by pressing SPLIT/RESET. The display will show the set-up countdown duration. [. . . ]