User manual HASBRO MCDONALDLAND BIRTHDAY GIRL DOLL

[. . . ] • Before connecting the appliance, make sure that the mains voltage is the same as the voltage indicated on the data label of the appliance and that the power outlet is connected to earth • Always turn off the appliance at the on/off switch before unplugging it. • If the appliance is left unused, always disconnect it from the mains. Never leave the appliance unattended with the cable plugged into the mains. • Always make sure the appliance is unplugged before performing maintenance work of any kind • Do not pull the power cable out of the socket, but grasp the plug itself to avoid damage to the socket. [. . . ] • In case of breakdown or malfunction switch off the appliance and never attempt to disassemble it, but refer to an authorized Service Centre. • In order to avoid prejudicing the safety of the appliance, use only original spare parts and accessories approved by the manufacturer. • Do not wind the power cable around the appliance, especially when the appliance is still hot. • During refilling with water, switch off and disconnect the appliance from the mains. • It is necessary to keep the unit in horizontal position during operation. • Do not direct the steam jet on electrical and/or electronic appliances. • Let the appliance cool down before cleaning it. • Before storing the appliance make sure that it has completely cooled down. • This appliances is equipped with safety devices which are to be replaced only by a suitably qualified technician. • Do not direct the steam jet at people, animals or debris. • Never place your hands inside the jet of steam. • Open the lid to fill the tank (4) (Fig. 2). • Fill the water tank with water up to the MAX level marked on the water tank. NOTE: It is possible to fill the tank while it is inserted. While refilling switch off and di- Steam ironing allowed For dry ironing, set thermostat (7) on ••• Steam ironing allowed For dry ironing, set thermostat (7) on •• Check the fabric's resistance to steam ironing or dry iron with thermostat (7) set on • sconnect the appliance from the mains. In hard water areas we recommend the use of KALSTOP, a special natural-base decalcifier which inhibits and breaks down limescale, making it easy to remove just by swilling out the tank with a little tapwater. Do not use demineralised water alone, but mix it with tap water as described above. Never use distilled water or scented water. • Close the cap again (4) and reinsert the water tank (3) until you hear the hook click. • Connect the cable plug to an earthed power supply of the correct voltage. • Press the ON/OFF switch (1); the ON indicator light (A) and the iron hearing light (11) will turn on. • Press the boiler switch (2); the steam pressure light (B) will come on and a buzzer will sound. • The sound emitted on switching on your appliance and periodically during use, is due to the water refilling system and is quite normal. - do not iron - steam ironing or treatment not allowed INSTRUCTIONS FOR USE Check the manufacturer’s label on the garment, and interpret the symbol on the label as follows: STEAM IRONING • Set the iron temperature to its maximum travel on the “COTTON - LINEN” steam position (fig. 3), by turning the dial (7). [. . . ] NOTE: • Both (B) and (11) lights go on and off during operation; this is quite normal and means that the electric resistance is operating to maintain constant the pressure in the boiler. • If steam does not come out of the iron, check that there is water in the tank (if the pressure light is not off all the way water comes out instead of steam). IRONING WITHOUT STEAM: • Press the ON/OFF switch (1), leaving the boiler switch off (2). • To dry iron, regulate the iron temperature using the slider (7) to the temperature required by the fabric (fig. 3). [. . . ]