User manual HASBRO MEMORY MATCH AND MOVE

[. . . ] All places of operation are characterised by their connection to the public low voltage power supply system. HASBRO CORPORATION: Breguetlaan 8, 1438BC Oude Meer The Netherlands We recommend recycling of used product. Please contact your dealer or iiyama service center. Recycle information is obtained via the Internet, using the address: http://www. iiyama. com You can access the Web page of different countries from there.  We reserve the right to change specifications without notice. [. . . ]  You are able to adjust the monitor’s angle up to 20° upward. Position Exit Select Press the NOTE Button lastly, it ends, all changes are saved in the memory. When button operations are aborted during adjustment, On-Screen Display disappears  button can be used to when the time set for the OSD Time Out has passed. Also, the return previous menu and turn off the On-Screen Display. Any changes are automatically saved in the memory when the On Screen Display  disappears. Turning off the power should be avoided while using the Menu. Position, Clock and Phase are saved for each signal timing. Except for  these adjustments, all other adjustments have only one setting which applies to all signal timings. OPERATING THE MONITOR 9 ENGLISH Color Adjust ADJUSTMENT MENU CONTENTS Auto Image Adjust Only Analog Input Auto Image Adjust Adjustment Item Auto Image Adjust * Problem / Option Button to Press Direct Adjust H. Position, Clock and Phase automatically. ENGLISH * For best results, use the Auto Image Adjust in conjunction with the adjustment pattern. See page 17 for SCREEN ADJUSTMENTS. Direct You can skip the Menu items and display an adjustment scale directly by using the following button operations. Auto Image Adjust: Pressing and holding of the  not displayed. Button for about 2 seconds when the Menu is 10 OPERATING THE MONITOR Picture Adjust Adjustment Item Contrast *3 Picture Adjust Problem / Option Too dull Too intense Too dark Too bright Off On Off 1 2 3 Typical Contrast Ratio Increased Contrast Ratio Normal Brightness of back-light is reduced. Button to Press Brightness *1, 2, 3 Adv. 5 / 15 / 30 / 60 seconds On Off On The background of OSD is mode transparent. iiyama Logo displayed when the monitor is turned on. iiyama Logo does not display when the monitor is turned on. The Power Indicator is turned Off. OSD Background I II I II II I IIII Opening Logo Off On LED NOTE Off Turn Off the Power Indicator when you are bothered by the light. Memory Recall Adjustment Item Memory Recall Memory Recall Problem / Option Factory-preset data is restored. Button to Press OPERATING THE MONITOR 15 ENGLISH ● Lock Mode <OSD Menu> 1. The OSD lock will be activated by pressing the front buttons try to access the OSD by pressing any of the buttons , , appear on the screen. The OSD lock will be deactivated by pressing the front buttons <Power Switch> 1. The power switch lock will be activated by pressing the front buttons and for 10 seconds. Locking the power switch means that won't be able to turn off the Monitor while the power switch is locked. If presses the power switch massage "Power Button Locked" will appear on the screen. The power switch lock will be deactivated by pressing the front buttons seconds. and again for about 10 and and and for about 10 seconds. [. . . ] Perform the adjustments described in OPERATING THE MONITOR, depending on the problem you have. If the monitor does not get a picture, skip to 2. Consult the following items if you cannot find an appropriate adjustment item in OPERATING THE MONITOR or if the problem persists. If you are experiencing a problem which is not described below or you cannot correct the problem, discontinue using the monitor and contact your dealer or iiyama service center for further assistance. The picture does not appear. [. . . ]