User manual HASBRO MY LITTLE LADYBUG BUGGY

[. . . ] Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Children should be supervised to ensure that they do not play with the appliance. The plug must be removed from the socket outlet before cleaning or maintaining the appliance. The use of an extension cord is not recommended. If your vacuum cleaner is not operating correctly, switch off the power supply and consult an authorized service agent. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Don't carry the vacuum cleaner by holding the hose. Use the handle on the vacuum cleaner set. Turn off the power switch before unplugging. safety information _03 contents ASSEMBLING THE CLEANER 05 OPERATING THE CLEANER 06 MAINTAIN TOOLS AND FILTER 06 06 06 ON/OFF Switch Power Cord Suction Control 07 TROUBLESHOOTING 07 08 10 11 12 13 13 Using accessory Maintain floor tools Emptying the dust bin When to clean the dust pack Cleaning the dust pack Cleaning the motor protection filter Cleaning the outlet filter 14 04_ contents assembling the cleaner OPTION 01 ASSEMBLING OPTION · Features may vary according to model. · Please do not press the button of dust bin handle when carrying machine. · For storage, park the floor nozzle. assembling _05 operating the cleaner ON/OFF SWITCH CAUTION · When removing the plug from the electrical outlet, grasp the plug, not the cord. POWER CORD SUCTION CONTROL · HOSE To reduce suction for cleaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open. 06_ operating maintain tools and filter USING ACCESSORY 03 Pipe (Option) · Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. MAINTAIN · To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. Accessory · Dusting brush for furniture. shelves, books, etc. · Crevice tool for radiators, crevices, corners, between cushions. maintain _07 MAINTAIN FLOOR TOOLS 2-Step Brush (Option) · Adjust the inlet lever according to the floor surface. · Remove waste matter completely if the inlet is blocked. Carpet Cleaning Floor Cleaning Pet Brush (Option) For improved pick-up of pet hair and fibre on carpets. Separate the dust bin dust full mark, light on by pressing the button. the lamp of filter check, or suction is noticeably reduced during cleaning. Before use, push the dust bin into the main body of the vacuum cleaner until you hear the "click" sound. - Empty into a plastic bag (recommended for asthma/ allergy sufferers) You may rinse the dust bin with cold water. 10_ maintain maintain tools and filter WHEN TO CLEAN THE DUST PACK If suction is noticeably reduced during cleaning, please check the dust pack as indicated below. 03 MAINTAIN Push the button to working If suction is noticeably reduced with the inlet floating 10cm above flat floor, clean it. When suction is noticeably reduced continuously, please cleaning the Dust Pack as shown in the following illustration. maintain _11 CLEANING THE DUST PACK 1. Remove the dust bin and dust pack as shown. 2. Remove the sponge and filter from the dust pack. 3. Wash the sponge and the filter of the dust pack with water. 4. Let the sponge and filter dry in the shade for more than 12 hours. 5. Put the sponge and filter into the dust pack. 6. Put the assembled dust pack into the main body. Make sure the filter is completely dry before putting it back into the vacuum cleaner. 12_ maintain maintain tools and filter CLEANING THE MOTOR PROTECTION FILTER 03 Take out both the dust bin and the dust pack. [. . . ] Put the assembled dust pack into the main body. Make sure the filter is completely dry before putting it back into the vacuum cleaner. 12_ maintain maintain tools and filter CLEANING THE MOTOR PROTECTION FILTER 03 Take out both the dust bin and the dust pack. MAINTAIN Remove the motor protection filter from the vacuum cleaner. Shake and tap the dust from it and put back in machine. CLEANING THE OUTLET FILTER OPTION - MICRO FILTER Press the fixed frame part at the back of the main body to remove. Remove and replace the blocked outlet filter. Replacement filters are available at your local Samsung distributor. OPTION maintain _13 troubleshooting PROBLEM Motor dows not start. [. . . ]