User manual HASBRO MY LITTLE PONY BUTTERFLY ISLAND ADVENTURE025

[. . . ] €¢ If the safety fuse fitted in the appliance blows, the appliance will be rendered inoperative. To restore normal operation the appliance will have to be taken to an authorised Technical Service Centre. €¢ In order to avoid that under unfavourable mains conditions, phenomena like transient voltage drops or lighting fluctuations can happen, it is recommended that the iron is connected to a power supply system with a maximum impedance of 0. €¢ Certain environmental conditions can cause instability in steam production and temperature for a short period of time. [. . . ] Tips: • Sort your garments out based on their cleaning symbol labels, always starting with clothes that have to be ironed at the lowest temperatures. €¢ If you are not sure what the garment is made of then begin ironing at a low temperature and decide on the correct temperature by ironing a small section not usually seen when worn. If you find that water is dripping out of the soleplate, set the temperature to a higher position (take care that the garment can be ironed on this heat temperature setting). €¢ At the beginning of each use, it is possible that drops of water will be dispensed alongside steam. Therefore, it is advisable to try the iron on the ironing board or a piece of cloth to start with. €œPulse steam” function* This appliance has a special function for tackling difficult creases. the “Pulse steam” function helps soften stubborn garments like jeans or linen faster. When the steam release button is activated, the steam generator will release three powerful shots of steam so that the steam reaches even deeper into the fabric. Press the steam release button (14*) on the top of the handle. Or (model dependent) Quickly press the steam release button (13) on the bottom of the handle twice (double-click) Remarks: • It is possible to stop the shots of steam by quickly pressing the steam button again. €¢ Some water drops may appear when you use the “Pulse steam” function for the first time. ) by placing the iron in a vertical position and pressing the steam release button (13 or 14*). Energy saving “eco” button If the “Energy saving” button (7) is switched on, you can save up to 25% of the energy and 40% of the water consumption (*), and still achieve good results when ironing most of your garments. It is advisable to use the normal energy setting only for thick and very wrinkled fabrics. (*) In comparison to the maximum setting. H) Set the temperature to the setting, without pressing the steam release buttons (13-14*). The water in the steam chamber will start evaporating. Wait until all the water inside the chamber has been evaporated. I) To clean the soleplate, immediately rub off any residue by running the hot iron over a dry cotton cloth. Holding your steam generator in the lateral position and using a jug, fill the boiler with 1/4 litre of water and replace the filter. Shake the base unit for a few moments, unscrew the filter again and empty the boiler completely over a sink or bucket. For best results, we recommend that this operation is performed twice. [. . . ] • The steam regulation is set to the minimum position. €¢ The selected temperature is too high and has damaged the garment. €¢ This is a regular consequence of continued use over a long period of time. €¢ Water is being pumped into the steam tank. [. . . ]